ENGLISH
8
(Original instructions)
Specifications
Voltage 3.6 V
No-load speed 200/min (rpm)
Torque 4.2Nm (3.9 ft-lb)
Bit holder 1/4” (6.5mm)
BDCS36F
Voltage 220-240~ 50/60Hz
Current
IN 300mA
Charging time 5 - 7 hr
Charger
Capacity 1.5Ah
Battery type Lithium-Ion
Battery
• Use the auto spindle lock to loosen very
tight screws or to firmly tighten screws.
• Always hold the tool and screwdriver bit
in a straight line with the screw.
• When screwing in wood, it is
recommended to drill a pilot hole with a
depth equal to the length of the screw. A
pilot hole guides the screw and prevents
splintering or distortion of the wood. For
the optimum size of the pilot hole, refer
to the table below.
• When screwing in hardwood, also drill a
clearance hole with a depth equal to half
the length of the screw. For the optimum
size of the clearance hole, refer to the
table below.
Accessories
The performance of your tool depends on
the accessory used. BLACK+DECKER and
Piranha accessories are engineered to high
quality standards and designed to enhance
the performance of your tool. By using
these accessories you will get the very best
from your tool.
This tool uses screwdriver bits with a 1/4”
(6.35 mm) hexagonal shank.
Maintenance
Your BLACK+DECKER tool has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Your charger does not require any
maintenance apart from regular cleaning.
Warning! Before performing any
maintenance on the tool, remove the
battery from the tool. Unplug the charger
before cleaning it.
• Regularly clean the ventilation slots in
your tool and charger using a soft brush
or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
Batteries
BLACK+DECKER batteries can be
recharged many times. At the end of
their useful life, discard batteries
with due care for our environment:
• Run the battery down completely, then
remove it from the tool.
• NiCd, NiMH and Li-Ion batteries are
recyclable. Take them to any authorized
repair agent or a local recycling station.
Screw size Pilot hole Ø
(softwood)
Pilot hole Ø
(hardwood)
Clearance
hole
No. 6 (3,5 mm) 2.0 mm 2.5 mm 4 mm
No. 8 (4 mm) 3.2 mm 3.5 mm 5.0 mm
To Next Page
Loading...
