Black & Decker BEHB101 - Page 20

18
ENGLISH
Select Alcohol Strength (Fig.J)
To select the amount of alcohol to be dispensed into the drink,
turn the strength selector dial
25
.
• Left: less alcohol
• Right: more alcohol
The strength LEDs
15
will turn on and off as you turn the
selector, indicating the strength of thedrink.
• - mocktail (no alcohol)
• - light alcohol content
• - regular alcohol content
• - strong alcohol content
Inserting a Capsule (Fig.H, I)

WARNING: Cut Hazard. Do not probe capsule holder area
withfingers.

WARNING: Pinch point. Keep away from capsule holder
when closing capsule holder lid.

WARNING: Use only Bartesian capsule. Use with any other
capsule may result in damage to theappliance.
IMPORTANT: Do not open capsule
20
.
IMPORTANT: Once the capsule is punctured, it may drip liquid.
To avoid this, place a capsule in the capsule holder
21
just
before mixing adrink.
1. Before inserting a capsule, place a glass or shaker on the glass
shelf
17
or drip tray
3
as described in the CHOOSE A GLASS
TRAY section
2. Select the capsule you wish touse.
3. To open the capsule holder, lift the capsule holder lid
22
until
it clicks intoplace.
4. Ensure the bar code
32
is clean from liquid and debris.
Wipe your thumb across the bar code before inserting
capsule into capsule holder.
5. Place the capsule in the capsule cup
23
located in the
holder. Ensure the capsule tab
24
faces to the left. The
cocktail maker will not operate if the capsule is inserted any
otherway.
6. Ensure the capsule sits fully in the capsulecup.
NOTE: The scanner inside the capsule holder scans the code on
top of the capsule. This allows the cocktail maker to pull from
the correct bottles so it dispenses the correctdrink.
7. Push the capsule holder lid down to close the capsule holder
until it clicks. Ensure the lid is fully closed beforeoperating.
NOTE: If the capsule code is successfully read, the bottle
LEDs
16
will light under the bottles that are being used. Ensure
each bottle is in its correctplace.
NOTE: If lights do not turn on, lift the capsule holder lid and use a
clean, dry towel to wipe the barcode scanner
31
and the capsule
barcode
32
as shown in Fig. I. Then, repeat step6.
The shaker LED
19
will light when a drink needs to be shaken.
In this case, use a shaker instead of a tallglass.
1. Push the glass shelf up so it hides away in thetower.
2. Ensure the drip tray cover is inplace.
3. Place a shaker on the drip traycover.
Choose a Glass Tray (Fig.G)
Place a glass or shaker on either the glass shelf
17
or drip
tray
3
, depending on the height of the glass being used. Refer
to the cocktail image on the capsule
20
for glassstyle.
NOTE: A glass or shaker must be in place before making a drink
to avoidspillage.
Short glass:
1. Pull the glass shelf down so it stands straight out from the
tower
18
.
2. Place a small glass on the glassshelf.
Tall glass:
1. Push the glass shelf up so it hides away in thetower.
2. Ensure the drip tray cover
4
is inplace.
3. Place a tall glass on the drip traycover.
Shaker:
On/Off (Fig.F)

WARNING: Do not interact with the cocktail maker while
it isoperating.
• To turn the cocktail maker on, push the "I" side of the power
switch
14
. The 4strength LEDs
15
and 6bottle LEDs
16
will
blink. When they become solid, the cocktail maker is ready
touse.
• To turn the cocktail maker off, push the "O" side of the power
switch. All LEDs will turnoff.
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicableregulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
sourcebattery pack before making any adjustments
or removing/installing attachments or accessories.
An accidental start-up can causeinjury.
• Gin
• Rum
• Vodka
• Tequila
• Whiskey
Removing Bottles (Fig.E)

CAUTION: Avoid spills while removingbottles.
1. Lift the straw lock
8
.
2. Slide the straw plug
11
and bottle off the cocktailmaker.
3. Pull the bottle stopper
13
out of the bottle and remove the
straw
7
.
NOTE: If the cocktail maker pauses for an empty bottle and you
press mix without replacing the bottle, it will skip to the next bottle
in the recipe. If that bottle is empty, it will pause again. Refer to the
PAUSE MODE section for moreinformation.