WARNING: Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body.
WARNING: ALWAYS use safety glasses. Everyday eye glasses are NOT safety
glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
•ANSI Z87.1 eye protection (CAN/CSA Z94.3)
•ANSI S12.6 (S3.19) hearing protection
•NIOSH/OSHA/MSHA respiratory protection
CAUTION: Wear appropriate hearing protection during use. Under some conditions
and duration of use, noise from this product may contribute to hearing loss.
SYMBOLS
The label on your tool may include the following symbols.
V ........................... volts A ......................... amperes
Hz ......................... hertz W ........................ watts
min ........................minutes
.......................alternating
current
......................direct current
n
o ....................... no load speed
..........................
Class II Construction
........................ earthing terminal
..........................safety alert symbol spm .....................strokes per
minute
SAVE THESE INSTRUCTIONS
4
2
3
4
1
1A
about 7/64 in. (2.7mm)
to 13/64 in. (5.1mm)
To Next Page
Loading...
Need help?
General
