15
ENGLISH
◆ On reassembling, the guide bar should be
turned through 180° and the sprocket nose
greased via the sprocket lubrication hole (19).
This ensures an even distribution of wear
around the guide bar rails.
◆ To turn the guide bar through 180°, remove
the small screw from the slider and re-fasten to
the opposite side of the bar.
Saw chain sharpening
If you are to get the best possible performance
from the tool it is important to keep the teeth of
the saw chain sharp. Guidance for this procedure
is found on the sharpener package. For this purpose
we recommend the purchase of the Black & Decker
saw chain sharpening kit (available from
Black & Decker service agents and selected dealers).
Replacing worn out chains
Replacement chains are available through retailers
or Black & Decker service agents. Always use
genuine spare parts.
Saw chain sharpness
The cutters will blunt immediately if they touch the
ground or a nail whilst cutting.
Saw chain tension
◆ Regularly check the chain tension.
Oil level
◆ Top up if low.
What to do if your chainsaw needs repair
Your chainsaw is in accordance with the relevant
safety requirements. Repairs should only be
carried out by a qualified persons using original
spare parts, otherwise this may result in considerable
danger to the user. We recommend you keep this
user manual in a safe place.
ACCESSORIES
Cat. no. Description
A6154 300 mm / 12" chain
A6155 350 mm / 14" chain
A6156 400 mm / 16" chain
A6039 Sharpening kit
A6027 0.5 l chain oil
PROTECTING THE ENVIRONMENT
Black & Decker provides a facility for
recycling Black & Decker products once
they have reached the end of their
working life. This service is provided free
of charge. To take advantage of this
service please return your product to any
authorised repair agent who will collect
them on our behalf.
TROUBLESHOOTING
If the tool does not operate correctly, check the following.
Fault Possible cause Action
Tool will not start. Blown fuse. Replace fuse.
Tripped RCD. Check RCD.
Mains lead not connected. Check mains supply.
Tool will not start
button will not slide. Front guard in the brake position Reset front guard.
Chain does not stop instantly
when the tool is switched off. Chain tension is too slack. Check chain tension.
Bar/chain appear hot/smoking. Oil tank empty. Check oil tank level.
Chain tension is too tight. Check chain tension.
Guide bar sprocket nose needs greasing.
To Next Page
Loading...
Need help?
General
