K
Kenneth BryantJul 26, 2025
What to do if the automatic line feed on my Black & Decker GL7033 Trimmer isn't working?
- KKelly CarrJul 26, 2025
If the automatic line feed isn't working, try these steps: First, keep the tabs depressed and remove the spool cover from the housing. Next, pull the cutting line until it protrudes 11 cm from the housing; if there's not enough line, install a new spool. Align the tabs on the spool cover with the cut outs in the housing and push the cover onto the housing until it snaps securely into place. If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the blade. Clean the spool cover and housing carefully. Remove the spool and check if the lever can move freely. Finally, remove the spool, unwind the cutting line, wind it on neatly again, and replace the spool.