6
ENGLISH
(Original instructions)
Item Description
240 grit large detail sanding sheet with two
replacement tips.
For a ne nish for large detail sanding.
(Part Number - X31019-XJ)
120 grit large detail sanding sheet with two
replacement tips.
For a medium nish for large detail sanding.
(Part Number - X31009-XJ)
60 grit large detail sanding sheet with two
replacement tips.
For a coarse nish for large detail sanding.
(Part Number - X31039-XJ)
120 grit detailed nger sanding sheet.
For a medium nish for detailed sanding.
(Part Number - X3277-XJ)
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting sanding mesh (g. A)
u Hold the tool with the sanding base facing upwards.
u Place the sanding mesh (5) onto the sanding base, mak-
ing sure that the holes in the sheet line up with the holes
in the base.
Fitting sanding sheets (g. B - Optional accessory)
u Detach the two additional diamond-shaped tips (7) from
the sanding sheet (6).
The diamond-shaped tip (7) can be reversed and replaced
when worn.
u When the front part of the tip is worn, detach it from the
sheet, reverse it and press it onto the sanding base again.
u When the whole tip is worn, remove it from the sanding
base and t a new tip.
For optimal dust collection, ensure the correct type of sanding
paper is used.
Finger attachment (g. C)
The nger attachment is used for ne detail sanding.
u Remove the screw (9).
u Remove the diamond-shaped tip (8) from the sanding
base.
u Fit the nger attachment (4) onto the sanding base.
u Fit and tighten the screw.
u Fit the appropriate sanding sheet onto the nger attach-
ment.
Fitting and removing the dust cassette (g. D)
u Slide the dust cassette (2) onto the tool and make sure
that it is securely located.
u To remove the dust casette, pull it to the rear and off the
tool.
Use
Warning! Let the tool work at its own pace. Do not overload.
Switching on and off
u To switch the tool on, slide the on/off switch (1) to the
forward position I.
u To switch the tool off, slide the on/off switch (1) to the back
position O.
Emptying the dust cassette (g. D, E & F)
The dust cassette should be emptied every 10 minutes of use.
u While holding the tool, pull the dust cassette (2) off the
tool.
u Remove the cassette lid (10).
u Shake the lid (10) and dust cassette (2) to empty the
contents, the lter (11) inside the lid (10) can be cleaned
with a soft dry brush.
u Ret the lid (10) to the dust cassette (2).
u Ret the dust cassette (2).
Maintenance
Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance, switch off and
unplug the tool.
u Regularly clean the ventilation slots in your tool using a
soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be tted:
u Safely dispose of the old plug.
u Connect the brown lead to the live terminal in the new
plug.
u Connect the blue lead to the neutral terminal.
Warning! No connection is to be made to the earth terminal.
Follow the tting instructions supplied with good quality plugs.
Recommended fuse: 5 A.
To Next Page
Loading...
