Black & Decker PW1350-BR

Questions and Answers

T
Tammy LindseyAug 7, 2025
Why is my Black & Decker PW1350-BR pump not reaching working pressure?
- B
  brandonkimAug 7, 2025
  If your Black & Decker Pressure Washer's pump isn't reaching working pressure, several issues could be the cause. First, a worn nozzle can be the culprit, requiring a replacement. Second, the water filter may be dirty, so clean it. Third, the water supply pressure might be too low, so fully open the water supply tap. Fourth, air could be getting sucked into the system; in that case, check the tightness of the hose fittings. Fifth, there might be air in the pump; switch off the appliance, repeatedly depress and release the gun trigger until the water flow is steady, and then switch the appliance back on. Lastly, the adjustable nozzle might not be positioned correctly; turn the adjustable nozzle to adjust it.
S
Shane LarsenAug 12, 2025
What to do if my Black & Decker PW1350-BR Pressure Washer motor fails to start?
- J
  Jeff WatsonAug 12, 2025
  If the motor of your Black & Decker Pressure Washer fails to start, first, ensure that the plug is firmly in the socket and that the mains voltage supply is present. If this doesn't solve the issue, and your model has this feature, use the tool (L) to unjam the motor from the hole at the rear of the appliance if it hasn't been used for a long time.
C
crodriguezAug 15, 2025
Why does my Black & Decker PW1350-BR Pressure Washer motor sound but fail to start?
- V
  Victoria WatsonAug 16, 2025
  If your Black & Decker Pressure Washer motor sounds like it's running but doesn't start, the issue might stem from an insufficient power supply. Check that the voltage of the mains power supply line matches what's indicated on the appliance's plate. Also, voltage loss could be due to the extension cable being used, in that case, check the characteristics of the extension cable.
D
dflemingAug 20, 2025
Why does my Black & Decker PW1350-BR pressure drop during use?
- R
  Ruth LopezAug 20, 2025
  If the pressure drops during the use of your Black & Decker Pressure Washer, it might be due to a few reasons. If you're using an external tank for water intake, connect the appliance to the mains water supply. If the intake water is too hot, reduce the temperature. Also, the nozzle might be clogged, so clean it.
T
tarmstrongAug 25, 2025
Why does my Black & Decker Pressure Washer AS motor start when the trigger is released?
- C
  Christopher MichaelAug 25, 2025
  If you have an AS version of the Black & Decker Pressure Washer and the motor starts even when the gun trigger is released, it might be because the nozzle is clogged, so clean the nozzle.
M
Marissa GatesAug 29, 2025
How to reduce noise in my Black & Decker PW1350-BR?
- J
  Jonathan RussellAug 29, 2025
  If your Black & Decker Pressure Washer is noisy, it might be because the water is too hot. Reduce the water temperature.
M
Maria MartinezSep 2, 2025
What to do if my Black & Decker PW1350-BR Pressure Washer AS has no water when trigger is depressed?
- K
  Kari GilesSep 2, 2025
  If you have an AS version of the Black & Decker Pressure Washer and there's no water delivery when the gun trigger is depressed (with the supply hose connected), the nozzle might be clogged. Clean the nozzle.