(Original instructions)
u
Only use the appliance in the upright
position, with the cutting line near the
ground. Never switch the appliance on
in any other position.
u
Move slowly when using the appliance.
Be aware that freshly cut grass is
damp and slippery.
u
Do not work on steep slopes. Work
across the face of slopes, not up and
down.
u
Never cross gravel paths or roads
while the appliance is running.
u
Never touch the cutting line while the
appliance is running.
u
Do not put the appliance down until the
cutting line has come to a complete
standstill.
u
Use only the appropriate type of cut-
ting line. Never use metal cutting line
or shing line.
u
Be careful not to touch the line trim-
ming blade.
u
Take care to keep the mains cable
away from the cutting line. Always be
aware of the position of the cable.
u
Keep hands and feet away from the
cutting line at all times, especially
when switching on the motor.
u
Before using the appliance and after
any impact, check for signs of wear or
damage and repair as necessary.
u
Never operate the appliance with
damaged guards or without guards in
place.
u
Take care against injury from any de-
vice tted for trimming the lament line
length. After extending new cutter line
always return the machine to its nor-
mal operating position before switching
on.
u
Always ensure that the ventilation slots
are kept clear of debris.
u
Do not use the lawn trimmer (edge
trimmer), if the cords are damaged or
worn.
u
Keep extension cords away from cut-
ting elements.
Electrical safety
#
This appliance is double insu-
lated; therefore no earth wire is
required. Always check that the
power supply corresponds to the
voltage on the rating plate.
u
If the supply cord is damaged, it must
be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
u
Electric safety can be further improved
by using a highsensitivity 30 mA Re-
sidual Current Device (RCD).
Labels on appliance
The following warning symbols are found on the appliance:
Read the manual prior to operation.
Wear safety glasses or goggles when operating
this appliance.
To Next Page
Loading...
