Black & Decker WP900 - Cord Contact Hazard; Abrasive Compounds Warning

WARNING: Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face and
body.
• Alwaysweareyeprotection.
• Besurebonnetissnuglyinstalledonpad.
• Keephandsandfingersawayfromrotatingbonnet.
• BeforeturningtheswitchtotheONposition,besurethepadisfreetorevolveharmlessly.
• Inspectthebonnetfrequentlyforwear,dirtorimbeddeddebris.
CAUTION: Do not allow the power cord to contact the rotating bonnet as it may become
quickly tangled around it. If this occurs, turn tool OFF and unplug the power cord before
attempting to untangle the cord. If the cord is damaged, have it repaired or replaced at your
local tool repair station.
• Neveruseadamagedortornbonnet.
• Wearproperclothing,shortsleeves,nothinglooseorbulky,suchasshopcoat,etc.
• Donotturntoolonunlessthepolishingbonnetisagainstsurfacebeingpolished.
• Beextremelycarefulwhenpolishingaroundsharporprotrudingobjectsonthecarbody.
• Thisproductisdesignedasapolisheronly.Donotuseasasander.
CAUTION: Do not use abrasive or rubbing compounds. The abrasive nature of
these products can damage painted surfaces.
CAUTION: Wear appropriate hearing protection during use. Under some conditions and
duration of use, noise from this product may contribute to hearing loss.
SYMBOLS
The label on your tool may include the following symbols.
V ........................... volts A ......................... amperes
Hz ......................... hertz W ........................ watts
min ........................minutes
.......................alternating
current
......................direct current
n
o ....................... no load speed
..........................
Class II Construction
........................ earthing terminal
..........................safety alert symbol .../min ..................revolutions or
reciprocations per minute
SAVE THESE INSTRUCTIONS
4
1
A
B
C
D
E
F
Descriptions Figure 1
A. Pad
B. Front handle
C. On/Off switch
D. End handle
E. Foam applicator bonnet
F. Polishing Bonnet