Black & Decker WP900 - Maintenance and Troubleshooting

• Foamapplicatorbonnets(E)aretobeusedonlyonce,thenthrownaway.
• DO NOT USE ABRASIVE COMPOUNDS. Liquid wax is recommended to use with this
polisher.
• Themostcommonerrorisapplyingtoomuchwax.Ifpadbecomessaturated,itwillnot
last as long and polishing will be more difficult and take longer.
Too much wax may have been applied if:
 •foamapplicatorbonnetcontinuallycomesoffpad;
 •buffingseemsdifficult.
• Thepolishingbonnetisonlytobeusedforthefinalbuff.Donotuseittoapplywax.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
To prolong pad life and shape, always store polisher with pad face up.
Remove bonnet from pad when polisher is not in use so that pad can dry out and retain its
original shape.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service organizations, always using identical replacement parts.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unitwillnotstart. •Cordnotpluggedin. •Plugtoolintoaworkingoutlet.
    •Circuitfuseisblown. •Replacecircuitfuse.(Iftheproduct
repeatedly causes the circuit fuse to
blow, discontinue use immediately
and have it serviced at a Black &
Decker service center or authorized
servicer.)
    •Circuitbreakeris •Resetcircuitbreaker.
tripped. (If the product repeatedly causes the
circuit breaker to trip, discontinue
use immediately and have it serviced
at a Black & Decker service center or
authorized servicer.)
    •Cordorswitchis •Havecordorswitchreplacedat
damaged. Black & Decker Service Center or
Authorized Servicer.
For assistance with your product, visit our website www.blackanddecker.com for the
locationoftheservicecenternearestyouorcalltheBLACK&DECKERhelplineat
1-800-544-6986.
7
ACCESSORIES
Recommended accessories for use with your tool are available from your authorized
service center. If you need assistance regarding accessories, please call: 1-800-544-6986
WARNING: The use of any accessory not recommended for use with this tool could
be hazardous. Do not use bonnets that tie with a string. The WP900 polisher is designed
for use with bonnets that use an elastic band to hold them on the platen.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service. Whether you need technical
advice, repair, or genuine factory replacement parts, contact the Black & Decker location
nearest you. To find your local service location, refer to the yellow page directory under
“Tools—Electric” or call: 1-800-544-6986 or visit www.blackanddecker.com