To Next PageTo Next PageWhy can't I control AVS-HDB-4TX by control device through the RS-232 port on my Black Box Extender?
If you cannot control the AVS-HDB-4TX with a control device like a PC via the RS-232 port on your Black Box Extender, first check that the RS-232 communication parameters are correct. If the problem persists, contact Black Box Technical Support at 724-746-5500 or info@blackbox.com.
General| Product Type | HDMI Extender |
|---|---|
| Model | AVS-HDB-4TX |
| Brand | Black Box |
| Category | Extender |
| Video Signal Supported | HDMI |
| Input Ports | 1 x HDMI |
| Type | HDBaseT |
| Maximum Resolution | 4K (3840 x 2160) |
| Transmission Distance | Up to 70 meters |
| Power Supply | External |
| Output Ports | 1 x HDBaseT |
Introduces the Video Extender - 4K HDMI, IR, RS-232, 4-Port Transmitter and its capabilities.
Lists the key features and compliance standards of the AVS-HDB-4TX transmitter.
Details the items included in the AVS-HDB-4TX package and contact information for missing items.
Describes the front panel of the AVS-HDB-4TX transmitter with a diagram and component identification.
Details the components of the AVS-HDB-4TX transmitter's back panel, with a diagram and table.
Provides essential safety and environmental guidelines for installing and operating the system.
Illustrates a typical application setup for the AVS-HDB-4TX video extender system.
Step-by-step instructions for connecting HDMI source, display, and other devices to the AVS-HDB-4TX.
Details the requirements for using straight-through twisted-pair cables for the AVS-HDB-RX connection.
Explains how to use IR signals for bi-directional transmission and control of devices.
Details how to connect and use RS-232 for controlling third-party devices connected to the receiver.
Provides instructions and configuration details for connecting to the device via a serial port using PuTTY.
Lists and explains commands for controlling the transmitter and outputs via RS-232.
Explains how to manage EDID information using DIP switches and serial commands.
