877-877-2269 | blackbox.com Page 11
Chapter 2: Overview
Table 2-1. Transmitter front- and back-panel components.
Number Component Description
1 Mode Switches the Mode for the RS-232 port.
Normal: RS-232 CATx passthrough.
Update: RS-232 firmware update.
2 Power LED ON: The transmitter is powered on.
OFF: The transmitter is powered off.
3 Status LED Blinking: The transmitter is working properly.
OFF: The transmitter is not working properly.
4 HDCP LED ON: HDCP video is being transmitted.
Flashing quickly: Non-HDCP video is being
transmitted.
OFF: No audio and video signal.
5 Link LED ON: CATx link is normal.
OFF/Blinking: No CATx link.
6 Barrel connector. 12-VDC power input
7 CATx OUT Connects to CATx IN port of receiver
8 3-pin Phoenix
connector
RS-232 passthrough or firmware update
9 DP IN Connects to a DisplayPort source
10 Audio IN Connects to an audio source such as a PC
11 Audio OUT Connects to an audio device such as an
amplifier.
12 USB Type B
connector
Connects to a device to be controlled, such as
a server, computer, etc.
To Next Page
Loading...
