IF AC IS BLOCKED BY STORM WINDOW
Add wood as shown in Fig.12 or remove the storm window before the air conditioner is installed. If Storm Window Frame must remain, be sure the drain holes or slots
are not caulked or painted shut. Accumulated Rain Water or Condensation must be allowed to drain out.
REMOVING AC FROM WINDOW
Turn AC off and disconnect the power cord.
Remove sash seal from between windows and unscrew safety sash lock. Remove screws installed through frame and frame lock. With 2 people, keeping a firm grip on
the air conditioner, raise sash, and carefully remove. Be careful not to spill any remaining water while lifting the unit from the window.
Store parts WITH air conditioner.
AIR CONDITIONER FEATURES
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
CAUTION: Please always wait 3 minutes when turning the unit off then on again, and when changing from cool to fan and back to cool. This prevents the
compressor from overheating & possible circuit breaker tripping.
To begin operating the air conditioner, follow these steps:
1. Set the thermostat to the highest number (coldest or cooler setting).
2. Set the selector control to the highest COOL setting.
3. Adjust the louver for comfortable airflow (see Air Directional Louvers). 4
4. Once the room has cooled, adjust the thermostat to the setting you find most comfortable.
5. Make sure that the airflow inside and outside is not obstructed by anything.
AIR DIRECTIONAL LOUVERS
The louvers will allow you to direct the airflow left or Right throughout the room as needed. Move the Levers from side to side until the desired Lek/Right direction is
obtained.
PARTS & FEATURES
To Next Page
Loading...