1. POWER: Turn on the unit by rotating the MODE dial to the desired COOLING or FAN setting. Turn the dial to OFF at any time to shut OFF the unit.
2. COOLING MODE: For maximum cooling set the MODE dial to HI COOL. The fan will automatically go to high and circulate the cool air throughout the room. The
fan will operate on low in LO COOL mode.]
3. THERMOSTAT: Turn the TEMP dial to set the desired temperature setting 1-7. For maximum cooling turn the TEMP dial to 7 (max cool).
4. FAN MODE: For fan-only modes, choose either HI FAN or LO FAN. The thermostat will not operate when in fan mode.
NOTE: To minimize wear and tear on the air conditioner, always wait at least 3 minutes before changing modes. This will help prevent the compressor from overheating
and the circuit breaker from tripping.
CLEANING & CARE
DANGER
1. Be sure to unplug the unit before cleaning or servicing.
2. Do not use gasoline, thinner, or other chemicals to clean the unit.
3. Do not wash the unit directly under a tap or using a hose. It may cause electrical danger.
4. If the power cord is damaged, it should be repaired by an authorized technician.
AIR FILTER CLEANING
CAUTION: Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards.
The air filter should be checked at least once a month to see if cleaning is necessary.
Trapped particles in the filter can build up and cause an accumulation of frost on the cooling coils.
1. Remove the filter by sliding it out from the front right side of the air conditioner.
2. Wash the filter using liquid dish soap and warm water. Rinse the filter thoroughly. Gently shake the filter to remove excess water. 3. Let the filter dry completely
before placing it back into the air conditioner.]
NOTE: Never use hot water over 40°C (104°F) to clean the air filter. Never attempt to operate the unit without the air filter.
CABINET CLEANING
Be sure to unplug the air conditioner to prevent shock or fire hazards. The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened
in a solution of warm water and mild liquid dishwashing detergent Rinse thoroughly and wipe dry.
Never use harsh cleaners, wax, or polish On the cabinet front.
Be sure to wring excess water from the cloth before wiping around the controls. Excess water in or around the controls may cause damage to the air conditioner.
Plugin the air conditioner.
WINTER STORAGE
If you plan to store the air conditioner during the winter, remove it carefully from the window according to the installation instructions. Cover it with plastic or return it to the
original carton.
TROUBLESHOOTING & WARRANTY
BEFORE YOU CALL FOR SERVICE
IF THE AIR CONDITIONER FAILS TO OPERATE:
To Next Page
Loading...