1. Plug power cord into a grounded 3 prong outlet.
2. Press RESET (on some units a green light will turn on).
3. Press the TEST button, the circuit should trip and cut all power to the air
4. Press the RESET button for use. You will hear a click and the A/C is ready for use.
5. The power supply cord must be replaced if it fails to trip when the TEST button is pressed and the unit fails to reset.
NOTES:
The RESET button must be engaged for proper use.
Do not use the power supply cord as an ON/OFF switch. The power supply cord is designed as a protective device.
CAUTION: A damaged power supply cord must be replaced with a new power supply cord. · The power supply cord contains new user-serviceable parts. Opening
the tamper-resistant case voids all warranty and performance claims.
NOTE: Your units cord and plug may differ from the shown
WARNING RISK OF FIRE
It is important the plug fits tightly into the wall outlet. If the plug does not fit securely and appears loose, it should not be used. Have a licensed electrician replace the
receptacle.
WARNING
SAFETY GUIDELINES
To prevent injury to the user or other people and property damage, the following instructions must be followed. Incorrect operation due to ignoring instructions may cause
harm or damage.
ALWAYS DO THIS
Your air conditioner should be used in such a way that it is protected from moisture. e.g. condensation, splashed water, etc. Do not place or store your air
conditioner where it can fall or be pulled into water or any other liquid. Unplug immediately.
Always transport your air conditioner in a vertical position and stand on a stable, level surface during use.
Turn off the product when not in use.
Always contact a qualified person to carry out repairs. If the supply cord is damaged it must be repaired by a qualified technician.
Keep an air path of at least 12 inches. all around the unit from walls. furniture and curtains.
If the air conditioner is knocked over during use. turn off the unit and unplug from the power supply immediately.
Always use the switch on the control panel to start or shut off the unit.
NEVER DO THIS
Do not operate your air conditioner in a wet room such as a bathroom or laundry room.
Do not touch the unit with wet or damp hands or when barefoot.
Do not press the buttons on the control panel with anything covers. Never use this appliance if it is not working properly,
or if it has been dropped or damaged.
Never use the plug to start and stop the unit.
Do not cover or obstruct the inlet or outlet grilles.
Do not use hazardous chemicals to clean or come into contact with the unit. Do not use the unit in the presence of or vapor such as alcohol, insecticides, gasoline,
etc.
Do not allow children to operate the unit unsupervised.
Do not use this product for functions other than those described in this instruction manual.
ENERGY SAVE
Use the unit in the recommended room size.
5,000 BTU up to 150 sq. ft.
Locate the unit where furniture cannot obstruct the airflow.
Keep blinds/curtains drawn.
Keep the filters clean.
Keep doors and windows closed to keep cool air in and warm air out.
SET UP & USE
NOTE: conditioner you have maybe slightly different.
WINDOW REQUIREMENTS:
Your air conditioner is designed to install in standard double-hung windows with opening widths of 23 to 36 inches (584mm to 914mm)
WARNING
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
To Next Page
Loading...