To Next PageTo Next PageHow to troubleshoot Black Max 2800 PSI when engine fails to start?
If your Black Max Pressure Washer engine fails to start, check the fuel tank and fill it if it's empty. Also, inspect the spark plug; replace it if it's shorted, fouled, or broken. Ensure the ignition lead wire is properly connected to the spark plug and replace it if shorted or broken.
What to do if my Black Max Pressure Washer engine is hard to start?
If your Black Max Pressure Washer engine is hard to start, it could be due to water in the gasoline. Drain the entire system and refill it with fresh fuel.
Why doesn't the detergent mix with the spray in my Black Max 2800 PSI Pressure Washer?
If the detergent fails to mix with the spray on your Black Max Pressure Washer, first check the spray selector on the 6-in-1 Change-Over Nozzle. Make sure it is set to either the short-range or long-range detergent setting. Also, verify that the detergent tank is not empty; add detergent if needed.
How to fix a Black Max 2800 PSI Pressure Washer engine that lacks power?
If your Black Max Pressure Washer engine lacks power, try cleaning or replacing the air filter.
What to do if my Black Max 2800 PSI Pressure Washer pump doesn't produce pressure?
If your Black Max Pressure Washer pump isn’t producing pressure, make sure the spray selector on the 6-in-1 Change-Over Nozzle is set to the 40º, 25º, or 0º setting. Other potential causes include an inadequate water supply (provide adequate water flow), a clogged nozzle (clean it), air in the line (pull the trigger to remove it), a leaking hose (replace it), or kinks in the hose (eliminate them). Also, ensure the choke is in the OFF (RUN) position. If the trigger handle or spray wand leaks, check connections and replace if needed. If the pump is faulty, it may need professional attention.
Why doesn't my Black Max 2800 PSI reach high pressure?
If your Black Max Pressure Washer machine doesn’t reach high pressure, it could be due to several reasons. First, the diameter of your garden hose might be too small; replace it with a 3/4 inch garden hose. Also, check for any restrictions in the water supply, such as kinks, leaks, or blockages in the garden hose. Ensure you have enough inlet water by opening the water source fully. Lastly, make sure the spray selector on the 6-in-1 Change-Over Nozzle is set to the 40º, 25º, or 0º setting.
General| Pressure | 2800 PSI |
|---|---|
| Flow Rate | 2.3 GPM |
| Motor Type | Electric |
| Power | 13 Amp |
| Pump Type | Axial Cam |
| Hose Length | 25 ft |
| Nozzle Types | 25°, 40°, Soap |
Contact for support, registration details, and website.
Warning against using E15 or E85 fuel due to potential damage and warranty voidance.
Highlights product engineering for dependability, ease of use, and safety.
User must read manual before use to reduce injury risk.
Highlights features for pleasant use, safety, performance, and dependability.
Comprehensive safety advice covering tool knowledge, guards, tools, children, work area, attire, footing, accessories, and maintenance.
Instructions on checks, unattended operation, engine cleanliness, exhaust, alertness, and drug/alcohol use.
Emphasizes work area inspection, dangerous environments, explosive atmospheres, smoking, and flammable materials.
Warnings about directing water streams and switch functionality.
Steps before cleaning or repair: shut off engine, stop parts, disconnect spark plug wire.
Caution on positioning, fire regulations, directing water streams, and clearing the work area.
Rules against carrying running machines, using specific chemicals, and operating on inclines.
Warning that high-pressure jets are dangerous if misused and must not be directed at people, animals, or devices.
Safety regarding adjustments, rotating parts, clearances, hot parts, and spark plug wires.
Guidelines for refueling outdoors, avoiding ignition sources, handling fuel with care, and proper storage.
Advice to use identical parts, maintain clearances, and ensure proper hose connection.
Explains DANGER, WARNING, CAUTION, and NOTICE signal words and their meanings.
Explains symbols for Safety Alert, Read Manual, Eye Protection, Wet Conditions, Hot Surface, Risk of Injections, Risk of Explosion, Risk of Fire.
Explains carbon monoxide hazards and kickback injury prevention.
Warns about electric shock and chemical burn risks from improper use or materials.
Lists engine type, fuel capacity, pressure, flow rate, and maximum inlet water temperature.
Details on nozzles, detergent system, engine switch, fuel tank, starter, spark arrestor, thermal relief, and trigger handle.
Steps for removing and inspecting product and accessories, with warnings about heavy lifting and damaged parts.
Lists needed tools and provides instructions for securing the handle and attaching the rear panel.
Guidance on connecting the spray wand to the trigger handle connector.
Steps to connect the high pressure hose to the trigger handle and the pump.
Steps to connect the garden hose, including pre-connection checks and water supply notices.
Steps to add and check engine lubricant levels, with warnings about overfilling.
Warning against E15/E85 fuel and clarification on acceptable ethanol content.
Safety warnings and steps for adding gasoline, including using a funnel and not overfilling.
Detailed steps for starting and stopping the engine, including pre-start checks and cool-down.
Instructions on how to operate the trigger, lock out, and positioning the wand.
Guidance on selecting the appropriate nozzle based on the cleaning task.
Steps for attaching and removing nozzles, including safety warnings.
Explains how to select spray patterns using the 6-in-1 nozzle.
Safety and care instructions for the high pressure hose to prevent damage.
Steps for using detergents, including selecting the correct nozzle setting and application technique.
Instructions on how to safely move the unit using the handle and wheels.
Advises contacting service for high-altitude modifications.
Advice on cleaning parts, avoiding solvents, and cleaning clogged nozzles.
Notes pump has no user-serviceable parts and provides storage instructions including cool-down and draining.
Recommends pump protector, draining lubricant, and servicing spark plug/air filter.
How to remove hoses, coil them, store the unit, and prepare it after storage.
A table outlining maintenance tasks and their recommended frequency.
Lists causes and solutions for engine failing to start, starting hard, or lacking power.
Addresses issues with detergent mixing and pump pressure loss, including causes and solutions.
Covers problems with machine not reaching high pressure due to hose, water supply, or nozzle settings.
Details the warranty terms, coverage, exclusions, and limitations for the pressure washer.
Emphasizes the need for a sales receipt and clarifies engine warranty coverage.
States limitations on implied warranties, consequential damages, and legal rights.
Warning about chemicals in the product and exhaust that may cause cancer or reproductive harm.
Instructions on contacting service dealers and obtaining repair parts, including model/serial number recording.
