Black Stone 2238 - Page 6

ENGLISH
BLACKSTONEPRODUCTS.COM/SUPPORT
OWNER’S MANUAL | ASSEMBLY GUIDE MODEL: 
OPTION A: Plug the power cord
into the motor.
OPTION B: Insert four (4) AA
batteries into the motor.
(DO NOT use the batteries and
the AC power supply at the
same time.)
STEP 05
To power the motor:
STEP 03
Set the pizza oven on its back.
Use twelve (12) M4x16 bolts [c.] to attach the four (4) legs to the
bottom of the pizza oven.
STEP 04
Insert one (1) AA battery (not included) under the
battery cap.
Screw the cap into place over the positive terminal.
STEP 06
Use two (2) M4x16 bolts [c.] to attach the bale panel to the
front panel.
Install the control knob by pushing it into place in the OFF position.
STEP 07
Slide the door shaft seat (L) onto the door shaft.
Use four (4) M4x16 bolts [c.] to attach the door shafts to the front
of the oven.
[c.] × 12
[c.] × 2
[c.] × 4
