ENGLISH
BLACKSTONEPRODUCTS.COM/SUPPORT
OWNER’S MANUAL | USING YOUR BLACKSTONE
❶
Push the control knob in to
start gas flowing.
❷
Turn the control knob
counter-clockwise to activate
the starter.
❸
Adjust the temperature to
desired level.
2. PIEzO-ELECTRIC GRIDDLE IGNITION
DO NOT lean over the appliance while lighting.
IGNITION INSTRUCTIONS
1. CHECK VALVES
STEP 01
Turn knob to OFF position.
STEP 02
Push in knob and release. Knob should spring back.
If knobs
DO NOT
spring back, replace valve assembly before using appliance.
spring back, replace valve assembly before using appliance.
STEP 03
Rotate knob to LOW then turn back to OFF. Knob should
turn smoothly.
❷
❶
❸
WARNING
If burner does not ignite with open gas supply valve, gas
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
Ensure gas is o at the supply shut o valve before checking
appliance valves.
STEP 01
Turn gas ON by turning the gas
cylinder handwheel counter-
clockwise 1 to 3 turns.
STEP 02
❶
Push the control knob in to
start gas flowing.
❷
Turn the control knob
counter-clockwise to activate
the starter.
❸
Adjust the temperature to
desired level.
❶
❷
❸
HEALTHY FLAME PATTERN YELLOW OR IRREGULAR
3. ALWAYS CHECK BURNER FLAME BEFORE USE.
STEP 01
Light burners and rotate knobs from HIGH to LOW.
STEP 02
Look below the cooking surface to view burners. When knob
is at HIGH, flames should be larger than when knob is at LOW.
3. ALWAYS CHECK BURNER FLAME BEFORE USE.
STEP 01
Light burner and rotate knob from LOW to HIGH.
STEP 02
Look below the turntable to view burner. When knob is at
HIGH, flames should be larger than when knob is at LOW.
❶
❶
Flickers of yellow color.
Flickers of yellow color.
❷
Dark blue color.
❸
Vibrant blue.
If there is a sudden drop or low
If there is a sudden drop or low
flame issue, please reference the
flame issue, please reference the
Troubleshooting chapter.
IF IGNITION DOES NOT OCCUR IN 5 SECONDS:
STEP 01
Turn the burner control knob OFF.
STEP 02
Wait 5 minutes.
STEP 03
Repeat the lighting procedure.
If burner does not ignite, please reference the Troubleshooting chapter.
If burner does not ignite, please reference the Troubleshooting chapter.
IF IGNITION DOES NOT OCCUR IN 5 SECONDS:
STEP 01
Turn the burner control knob OFF.
STEP 02
Wait 5 minutes.
STEP 03
Repeat the lighting procedure.
If burner does not ignite, please reference the Troubleshooting chapter. If burner does not ignite, please reference the Troubleshooting chapter.
HEALTHY FLAME PATTERN YELLOW OR IRREGULAR
❶❶
Flickers of yellow color. Flickers of yellow color.
❷❷
Dark blue color. Dark blue color.
❸❸
Vibrant blue. Vibrant blue.
If there is a sudden drop or low If there is a sudden drop or low
flame issue, please reference the flame issue, please reference the
Troubleshooting chapter. Troubleshooting chapter.
MODELS: 2321 • 2321CA
To Next Page
Loading...
