BLACKSTONEPRODUCTS.COM/SUPPORT
ENGLISH
| OWNER’S MANUALASSEMBLY GUIDEMODEL:
STEP 05
Use four (4) M6x14 screws [a.] to attach the motor to the
underside of the burner box.
Note: Ensure that the rotating shaft is aligned before tight-
ening screws.
STEP 06
Pull the regulator and switch cable out of the base
(cut zipties).
Plug the switch cable into the motor.
STEP 04
Insert the rotating shaft through the bronze sleeve and into
the bearing bracket.
STEP 08
Remove the feet from the legs.
Option A: Plug the power cord
into the motor.
STEP 09
Use eight (8) M6x14 screws [a.]to attach the four (4) legs to
the underside of the burner box.
Option B: Insert two (2) D
batteries into the motor.
(DO NOT use the batteries and
the AC power supply at the
same time.)
STEP 07
To power the motor:
[a.] × 4
[a.] × 8
To Next Page
