Black Stone 6824 - Page 8

ENGLISH
BLACKSTONEPRODUCTS.COM/SUPPORT
OWNER’S MANUAL | ASSEMBLY GUIDE MODEL: 
STEP 11
Use eight (8) M6x14 screws [a.] to attach two (2) wheel
assemblies and one (1) cart side panel to one (1) cart frame.
Repeat with the other cart frame.
STEP 12
Use six (6) M6x14 screws [a.] to attach the cart frames to the
cart base.
Note: DO NOT fully tighten screws yet.
STEP 13
Use four (4) M6x14 screws [a.] to attach the front cart panel
to the cart frames.
Use four (4) M6x14 screws [a.] to attach the front logo panel to the
cart frames.
Note: DO NOT fully tighten screws yet.
STEP 14
Use two (2) M6x14 screws [a.] and two (2) M6 nuts [d.] to
attach the orange background panel to the front logo panel.
Note: DO NOT fully tighten screws yet.
STEP 15
Use four (4) M6x14 screws [a.] to attach the rear cart panel
to the cart frames. (Be sure that the angles match. DO NOT install
upside down.)
Note: Tighten all screws from the previous five steps.
STEP 10
Screw the four (4) caster wheels into the bottom of the four
(4) wheel brackets. (Ensure that the wheels are locked.)
[a.] × 6
[a.] × 16
Rear of the cart
Rear of the cart
[a.] × 8
[a.] × 4
[a.] × 2
[d.] × 2
Push to lockPush to lock
