Black Stone CASCADE CAPRI CCF-21-SG

To Next Page

■ On the back of the remote, press

the release button on the bottom

right hand side. This will allow

the tray containing the battery to

be released. Release the tray by

squeezing the small lip and pulling

down the tab at the bottom of the

remote (Fig. 2).

■ Replace the battery with one new

CR2032 button battery. Important:

Install only new batteries of the

same type in your product. Failure to insert batteries

in the correct polarity, as indicated in the battery

compartment, may shorten the life of the batteries or

cause batteries to leak. Do not mix old and new bat-

teries. Do not mix Alkaline, Standard (Carbon-Zinc)

or Rechargeable (Nickel Cadmium) or (Nickel Metal

Hydride) batteries. Danger of explosion if battery is

incorrectly replaced.DO NOT DISPOSE OF BATTERY IN

FIRE, BATTERY MAY EXPLODE OR LEAK

■ This product contains a button cell battery. If swal-

lowed, it could cause severe injury or death in just 2

hours. Seek medical attention immediately.

This product contains a button battery. If swallowed, it could cause severe injury

or death in just 2 hours. Seek medical attention immediately.

Blackstone International Ltd. and other trademarks are the property of the respective owners. All other brand names

and logos are registered trademarks of their respective owners.

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may

not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired

operation. Note: This equipment has been tested and found to

comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC rules and Industry Canada ICES-003. These

limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a

residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interfer-

ence to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit differ-

ent from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician

for help.

Note: This device complies with part 15 of the FCC rules and

Industry Canada ICES-003. Operation is subject to the following

two conditions: (1) This device may not cause harmful interfer-

ence, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

CLEANING AND STORAGE

■

■ Use a soft cloth to wipe the housing. DO NOT use water

or any other chemical solution or cleaner. DO NOT soak

or immerse the fan in water or liquid.

■ DO NOT ATTEMPT TO TAKE THE FAN APART.

■ Store in a dry place away from excessive heat and direct

sunlight.

■ Regular cleaning will ensure optimum performance and

appearance of the fan.

■ DO NOT kink the power cord when storing or while in use.

TROUBLESHOOTING

HAVE A PROBLEM? PLEASE CONTACT CUSTOMER SERVICE.

Should you have any questions or comments please contact us at: customerservice@blackstoneltd.com

WARRANTY: This fan includes a one (1) year warranty, which covers manufacturer defects and workmanship under normal use.

Warranty is offered only to the original purchaser. Proof of purchase is required. Proof of purchase constitutes a dated sales

receipt. This warranty is void if the fan(s) have been subject to abuse such as: being dropped which could result in damage

to the fan cabinets, motors, fan controls, etc. immersion in or exposure to water, exposure to excessive heat, outdoor usage,

any use other than household use, disassembly, repair or alteration by anyone other than an authorized service provider, use

on improper voltage or current, or any use contrary to the user instructions. Batteries and battery life are not covered in this

warranty. DO NOT attempt to repair any electrical or mechanical functions of this product; doing so will void this warranty and

could lead to injury.

MADE IN CHINA | Distributed by: Blackstone International, Ltd.

A. To disconnect, grasp the plug and pull it from the wall outlet. DO NOT unplug by pulling the cord.

B. Open fuse cover. Slide open the fuse access cover located on the top of the plug towards the plug

blades.

C. Remove the fuse by turning the fuse over (end over end) carefully making sure not to break the fuse.

(See Fig. 2)

E. Close fuse cover. Slide close the fuse access cover toward the fan cord on the top of the plug.

F. The fan plug uses a 5 amp fuse.

G. In the event of loss of power please check the fuse located within the plug.

Fig. 1

Fig. 2

Fig. 3

Problem

■ Fan does not operate

Possible

Cause

■ Plug is not fully

inserted into wall

■ Fuse in plug is tripped

Solution

■ Make sure plug is fully plugged

into wall

■ Replace fuse

FCC STATEMENT OF COMPLIANCE

REMOTE CONTROL BATTERY REPLACEMENT

USER SERVICING INSTRUCTIONS

OSCILLATING FAN

INSTRUCTION

MANUAL

MODEL: CCF-21-SG,

CCF-21-CG,

CCF-21-P, CCF-21-W,

CCF-21-B

VOLTAGE: 120V AC

FREQUENCY: 60Hz

CURRENT: 52 W

IMPORTANT, RETAIN FOR FUTURE REFERENCE:

READ CAREFULLY | FOR HOUSEHOLD USE ONLY

Use Only With a Fuse Rated 5 Amperes, 125 Volts.

Fig. 1 Fig. 2

●

Need help?

Do you have a question about the Black Stone CASCADE CAPRI CCF-21-SG and is the answer not in the manual?

Summary

Cleaning and Storage Instructions

Cleaning Procedures

Wipe housing with soft cloth. Avoid water, chemicals, and disassembly.

Storage Guidelines

Store in a dry, cool place away from heat and sunlight. Do not kink the power cord.

Troubleshooting and Servicing

Common Problems

Addresses fan not operating, fuse issues, and plug connection problems.

User Servicing

Instructions for unplugging, accessing and replacing the fuse in the plug.

Remote Control and Battery

Battery Replacement

Details on accessing the battery compartment and installing a new CR2032 battery correctly.

Product Information and Support

Warranty and Contact

Covers one-year warranty, exclusions, and customer service contact details.

FCC Compliance

Statement on device compliance with FCC rules for digital devices and interference.

Critical Safety Warnings

Button Battery Hazard

Warning about severe injury or death from swallowing button batteries; seek immediate medical attention.

General Safety Precautions

Electrical Safety

Avoid water, damaged cords, explosive fumes, and ensure proper outlet connection.

Usage Restrictions

For household use only, dry level surface, avoid outdoors, open flame, and children's supervision.

Cord Safety

Do not run cord under carpeting or rugs. Arrange away from traffic areas.

Product Operation Controls

Power and Timer

Controls for turning the fan on/off and setting automatic shutoff timers.

Speed and Mode Selection

Options for selecting fan speed (ECON, LOW, MED, HIGH) and wind modes.

Fan Mode Explanations

Standard and Evening Modes

Describes Standard wind and how Evening wind mode cycles through speeds.

Breeze Wind Mode

Explains how Breeze wind mode randomly selects speeds for an outdoor feel.

Important Notices and Warnings

Fuse Replacement Notice

Guidance on fuse replacement, avoiding force, and when to seek professional help.

Polarized Plug Safety

Explanation of the polarized plug and how to ensure correct outlet fit for safety.

Battery Safety Reminder

Reiteration of battery safety, securing compartment, and proper disposal.

This document provides comprehensive instructions for the safe and effective use, maintenance, and troubleshooting of an oscillating fan. It emphasizes safety precautions, particularly regarding electrical hazards and the handling of button cell batteries.

Function Description

The oscillating fan is designed to provide cooling and air circulation within a household environment. It features multiple speed settings and operating modes to suit various preferences and needs. The fan can be controlled both directly on the unit and via a remote control.

Key functions include:

Speed Selection: The fan offers four different speed settings: LOW, MED, HIGH, and ECO (Economy). These settings allow users to adjust the intensity of the airflow.
Mode Selection: Three distinct modes are available:
- Standard Wind: This mode provides a consistent airflow, similar to a traditional fan.
- Evening Wind: This mode simulates a gentle, natural breeze, ideal for nighttime use. The fan's speed gradually decreases over time, starting from a selected speed (LOW, MED, or HIGH) and reducing to LOW after a set period.
- Breeze Wind: This mode offers a dynamic, randomly selected wind speed, mimicking an outdoor breeze.
Oscillation: The fan head oscillates to distribute air across a wider area, enhancing air circulation in a room. This feature can be turned on or off as desired.
Timer Function: An automatic shut-off timer can be set for up to 15 hours, allowing users to program the fan to turn off after a specified duration. A LED indicator displays the cumulative time remaining.
Remote Control: A dedicated remote control provides convenient operation of all fan functions from a distance, including power, speed, mode, oscillation, and timer settings.

Usage Features

The manual provides detailed guidance on how to operate the fan safely and effectively:

Powering On/Off: The fan is turned on and off using the designated power button on both the unit and the remote control.
Setting Speed: Users can cycle through the four speed settings (LOW, MED, HIGH, ECO) using the speed selection button.
Selecting Mode: The mode button allows users to switch between Standard Wind, Evening Wind, and Breeze Wind.
Activating Oscillation: The oscillation button toggles the fan's oscillating movement.
Setting the Timer: The timer button allows users to set the automatic shut-off timer in 1-hour increments, up to 15 hours.
Remote Control Battery Replacement: Instructions are provided for replacing the CR2032 button battery in the remote control. This process involves pressing a release button, sliding out the battery tray, replacing the battery with a new one, and reinserting the tray. Emphasis is placed on correct polarity and not mixing battery types.

Safety Precautions:

The manual highlights numerous safety warnings to prevent injury, fire, and electrical shock:

Electrical Safety: Always unplug the fan before cleaning or maintenance. Do not use the fan with a damaged cord or plug. Do not immerse the fan in water. Avoid running the power cord under carpets or in high-traffic areas. The fan uses a fused plug, and instructions are provided for checking and replacing the 5-amp, 125-volt fuse if tripped.
Button Cell Battery Safety: A critical warning is issued regarding the button cell battery in the remote control. If swallowed, it can cause severe injury or death in just 2 hours, and immediate medical attention is required. Keep batteries out of reach of children.
General Usage: Do not attempt to disassemble or repair the fan. Use the fan only for household purposes and indoors. Keep the fan away from open flames, cooking appliances, and excessive heat. Do not operate the fan if the housing is damaged or if any part is missing.
Children and Pets: Supervise children and pets when the fan is in use. Do not allow children to play with the fan.

Maintenance Features

Proper maintenance ensures the longevity and optimal performance of the fan:

Cleaning: Before cleaning, always turn off and unplug the fan. Use a soft cloth to wipe the housing. Avoid using water, chemical solutions, or cleaners. Do not soak the fan.
Storage: Store the fan in a dry place, away from excessive heat and direct sunlight. Avoid kinking the power cord during storage.
Fuse Replacement: Detailed instructions are provided for accessing and replacing the fuse located in the fan's plug. This involves sliding open the fuse access cover, carefully removing the old fuse, inserting a new 5A, 125V fuse, and closing the cover.

Troubleshooting:

A troubleshooting section addresses common issues:

Fan Not Operating: If the fan does not operate, check if the plug is fully inserted into the wall and if the fuse in the plug is tripped. Solutions include ensuring the plug is fully inserted and replacing the fuse if necessary.

Warranty and Compliance:

The fan comes with a one-year warranty covering manufacturer defects and workmanship under normal use. The warranty is void if the fan has been subjected to abuse, improper use, unauthorized repairs, or use contrary to the instructions. The warranty does not cover batteries.

The device complies with FCC and Industry Canada ICES-003 rules, ensuring it meets standards for electromagnetic compatibility. Users are advised on measures to correct potential interference with radio or television reception.