Blackbox GO! - Advanced Functions; TDMA DMO 2 Timeslots; Scan List and Scanning

8
Advanced Functions
You can use the following advanced functions:
TDMA DMO 2 time slots
Scan list…
Scanning…
SMS…
Set the power level
VOX
Talk around
Remote monitor
Remote alarm
Remote kill
TDMA DMO (Direct mode operation) 2 times slots
DMO 2 times slots will make one frequency point which can be used for two channels at the same time. It
will save the frequency resources.
Scan List
You can create a scan list and assign it to a single channel or call group. The radio scans the channel or call
group queue in the list on a cycle basis to check whether someone is speaking on the current channel. The
Radio supports a maximum of 3 scan lists, and each list supports a maximum of 16 members.
Scanning
When you start scanning, the Radio scans the pre-programmed scan list on a cycle basis to check whether
someone is speaking on the current channel. The LED indicator is flashing red.
Scanning modes
Automatic scanning (automatically): When you select a channel or call group for which automatic
scanning is enabled, the Radio automatically starts scanning.
Start and Stop Scanning
Perform the following steps:
1. Press the pre-programmed scan button. Or turn the channel selection knob to select a channel for
which automatic scanning is enabled.
2. When scanning is started, the LED indicator is flashing orange. When scanning is stopped, the LED
indicator is not lit.