Why is there no AC power to the battery charger on my Blackfin 252 Center Console Boat?
If there's no AC power to the battery charger on your Blackfin Boat, even with the shore cord properly connected, check: * If the breaker at the shore outlet is off: Activate breaker. * If the shore power cord is damaged or defective: Replace the cord. * If the shore inlet connection is corroded or defective: Replace the inlet connection.
What to do if my Blackfin Boat wanders and won't hold course?
If your Blackfin Boat wanders and won't hold a course at cruise speeds, consider these potential causes and solutions: * Air in the steering system: Fill and bleed the system. * Corroded or misadjusted engine steering tab: Replace or adjust the steering tab. * Binding engine steering spindle: Grease the spindle.
Why is my Blackfin Boat engine losing RPMs even though the hull is clean?
If your Blackfin Boat engine is losing RPMs despite a clean hull and non-overloaded condition, the issue might stem from: * A sticky anti-siphon valve in the fuel line: Remove, clean, or replace the anti-siphon valve. * A dirty remote gasoline fuel filter: Inspect and replace the fuel filter. * A dirty primary fuel filter on the engine: Inspect and replace the fuel filter. * A malfunctioning electronic engine control system: Repair the engine control system. * A malfunctioning fuel injection system: Repair the fuel injection system.
Why is the hydraulic steering on my Blackfin 252 Center Console unusually hard?
If the hydraulic steering on your Blackfin Boat feels unusually hard, check the following: * Blown fuse or tripped circuit breaker: Replace the fuse or reset the breaker. * Internal fuse in the power steering pump system blown: Refer to the steering owner's manual for fuse location and replace the fuse or contact your dealer for assistance. * Kinked or collapsed steering line: Replace the kinked or collapsed line.
Why does my Blackfin 252 Center Console vibrate at cruising speeds?
If your Blackfin Boat vibrates at cruising speeds, consider these potential causes: * Damaged propellers that need repair. * A bent propeller or propeller shaft: Repair or replace damaged components. * Running gear fouled by marine growth or rope: Clean running gear. * Improperly trimmed engines: Trim engines.
Why won't the porcelain head flush on my Blackfin 252 Center Console Boat?
If the porcelain head on your Blackfin Boat will not flush, it could be due to: * A full holding tank: Pump out the holding tank. * A defective flush valve: Replace the flush valve.
Why does the washdown pump run, but no water comes out on my Blackfin 252 Center Console Boat?
If the washdown pump runs on your Blackfin Boat, but no water is pumped, check: * If the thru-hull valve is not open: Open valve. * If the in-line sea strainer for the pump is clogged: Clean the sea strainer.
Why won't my Blackfin 252 Center Console holding tank empty?
If your Blackfin Boat's holding tank won't empty, consider the following: * A clogged holding tank vent: Clean the vent and vent hose. * A vacuum leak in the hose from the holding tank to the deck pump out fitting: Tighten loose fittings or replace damaged hoses.
Why won't the fresh water pump on my Blackfin 252 Center Console Boat turn off?
If the fresh water pump on your Blackfin Boat fails to turn off after all outlets are closed, check for: * A leak in a pressure line or outlet: Repair the leak. * An air leak in the intake line: Repair the air leak. * A defective pressure switch: Replace the pressure switch. * Low voltage to the pump: Check for corroded or loose wiring connections or low battery. * A clogged strainer: Clean strainer. * A defective pump: Repair or replace the pump.
Why won't my Blackfin Boat's bilge pump run when I use the manual switch?
If the bilge pump on your Blackfin Boat won't run when the manual switch is activated, consider these possibilities: * The circuit breaker supplying the switch has tripped: Reset the circuit breaker. * The battery switch is off: Turn on the battery switch. * The pump impeller is jammed by debris: Clean pump impeller housing. * The wire connections in the bilge have corroded: Replace connectors and secure above the bilge waterline. * The switch is defective: Replace the switch. * The pump is defective: Replace pump.
Details essential safety gear mandated by regulations for passenger safety.
Addresses bilge/fuel fires and essential first aid procedures for emergencies.
Covers engine alarms, neutral safety, and stop switches for safe operation.
Explains navigational rules and vessel right-of-way for safe boating.
Essential pre-departure checklist for safe operation of the boat.
Covers docking, anchoring, and handling system failures or emergencies.
Details engine oil requirements and cooling system operation.
Discusses propeller selection and addressing performance issues.
Explains various engine gauges and monitoring systems for optimal operation.
Describes operation of engine throttle and shift control levers.
Covers neutral safety, stop switches, and power tilt/trim functions.
Details hydraulic steering, joystick controls, and trim tab functions.
Explains battery configurations, switches, and circuit protection.
Covers ignition panels and accessory switch functions for boat equipment.
Details circuit protection, breakers, fuses, and battery charging systems.
Introduction to the fresh water system and its usage procedures.
Procedures for cleaning strainers and sanitizing the fresh water tank.
Description of raw water systems and their operational procedures.
Covers baitwell function, water circulation, and system upkeep.
Overview of hull drainage and cockpit/deck scupper systems.
Details bilge drainage, garboard plugs, and compartment drains.
Routine checks and cleaning for maintaining proper drainage.
Covers deck rails, cleats, anchor lockers, and windlass operation.
Details hull structure, swim platform, and boarding ladder usage.
Describes hatches, transom doors, rod racks, and seating in the cockpit.
Details the head compartment, battery panel, and storage areas.
Covers portable and porcelain marine toilets and their use.
Guidance on hull cleaning, bottom paint, and sacrificial anode maintenance.
Maintenance for upholstery, canvas, and stainless steel hardware.
Procedures for cleaning the cabin interior and bilge area.
Procedures for preparing the boat for long-term storage.
Steps for winterizing various boat systems to prevent damage.
Procedures for preparing the boat for use after storage.
Wiring diagrams for the boat's hull and deck electrical systems.
Wiring diagrams for the console and helm switch panels.
Solutions for common boat system and performance problems.
Technical specifications for the 252 Blackfin model, including dimensions and capacities.
To Next Page
General