12 April 2017 • Blackmagic Special Report
EVF Monitor cable plugs into the SDI OUT BNC connector
EVF’s 4-pin XLR
power cable plugs into
the +12 V DC OUT
connector
The handgrip adjustment
thumbscrew is beneath this
rubber cover
Attach the handgrip
extension to the
camera right rosette.
Attach the shoulder mount to the camera’s base with two supplied
3/8-16 screws. The shoulder pad slides forward and back for
best balance. The rear two threads on the camera base seem to
balance best.
Handgrip
LANC cable
Blackmagic URSA Mini Shoulder Kit
Blackmagic URSA Mini 4.6K
Plug in the handgrip’s LANC
connector
3/8-16 tripod mounting thread
V-Lock
Thumbscrew to
tighten EVF rotation
Thumbscrew to lock
EVF in-out position
To Next Page
Loading...
