6
ENGLISH
(Original instructions)
u Do not expose the battery to water.
u Do not store in locations where the temperature may
exceed 40 °C.
u Charge only at ambient temperatures between 10 °C and
40 °C.
u Charge only using the charger provided with the tool.
u When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Do not attempt to charge damaged batteries.
Chargers
u Use your BLACK+DECKER charger only to charge
the battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
u Never attempt to charge non-rechargeable batteries.
u Have defective cords replaced immediately.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
$
The charger is intended for indoor use only.
Read the instruction manual before use.
Labels on tool
The following pictograms along with the date code are shown
on the tool:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear a dust mask.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Dust collection cassette
3. Sanding base
4. Finger attachment
5. Battery
Accessories
The accessories supplied with your sander depend upon the
model that you have purchased. All the accessories listed
below are available in our range. If you require an accessory
that is listed below but is not supplied with your sander please
visit our website at www.blackanddecker.eu.
The performance of your tool depends on the accessory used.
BLACK+DECKER accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you will get the very best
from your tool.
Item Description
Detail nger.
For small hard-to-reach areas. The detail
nger can be used for light sanding and
for sanding into corners.
(Part Number - X32214-XJ)
240 grit sanding mesh.
For a ne nish for large detail sanding.
(Part Number - X39132-XJ)
120 grit sanding mesh.
For a medium nish for large detail
sanding.
(Part Number - X39127-XJ)
80 grit sanding mesh.
For a coarse nish for large detail
sanding.
(Part Number - X39122-XJ)
240 grit large detail sanding sheet
with two replacement tips.
For a ne nish for large detail sanding.
(Part Number - X31019-XJ)
120 grit large detail sanding sheet
with two replacement tips.
For a medium nish for large detail
sanding.
(Part Number - X31009-XJ)
60 grit large detail sanding sheet with
two replacement tips.
For a coarse nish for large detail
sanding.
(Part Number - X31039-XJ)
To Next Page
Loading...
Need help?
General
