Assembly
Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit.
1. Carefully turn the Main Body upside-down on a scratch-free and stable surface. Be careful to
prevent damage to the cosmetic finish or your floor surfacing.
2. Attach the feet to the base of the heater by aligning the built-in position pins with the position
holes on the base of the heater and fixing a screw into the hole between the two position holes.
Use two screws for each foot.
6
WARNING: Heater must not be used without the feet fitted.
This appliance has been supplied with ‘1 way screws’ for permanent installation of
the feet. This is a safety requirement for the New Zealand and Australian market.
To Next Page
Loading...
