Black+Decker BH1607 - Overheat Safety Feature; Tip-Over Safety Feature

Page 5
OVERHEAT SAFETY FEATURE
The heater is equipped with a overheat safety feature. When the Heater’s internal
components reach certain temperature that could cause overheating and the unit
will automatically shut o. The heater can be reset by unplugging it from the wall
outlet. After it has cooled down [approximately 30 minutes], plug the unit back
in and turn it back on. In certain cases the over heating could cause possible
fire, the heater will automatically shut o. If this should occur, please contact our
customer Satisfaction center at 844-299-0879.
TIP-OVER SAFETY FEATURE
This heater is equipped with a tip-over safety feature. Once the heater is tipped
over, an internal switch will automatically shut the heater off. Once the heater is
restored to an upright position, the heater will reset. To continue operation, turn
heater back on.
WARNING
It is normal for the power cord to feel warm to the touch; however, a
loose fit between the outlet and the plug may cause overheating of
the plug. If this occurs, try inserting the plug into a dierent outlet.
Contact a qualified electrician to inspect the original outlet for
damage.
SAFETY INFORMATION