ENGLISH
(Original instructions)
7
INSTALLING THE PRODUCT
♦ Pull the rear cover handle to remove it (FIG1)
♦ Remove the plastic package from the lter (FIG2)
♦ Install the lter into the machine (FIG3)
♦ Fasten up the rear cover and connect to the power
source (FIG4)
USE:
♦ The appliance can be used directly connected to the
main.
♦ Extend the cable completely before plugging it in.
♦ Attach the appliance to its base / connector making sure
that it is correctly tted into place.
♦ Connect the appliance to the mains.
♦ Guide the appliance to direct the ow of air in the desired
direction.
♦ Turn the appliance on, by using the on/off button (4).
♦ Select the appliance function desired.
♦ Select the desired speed.
FAN SPEED MODE
Cycles through fan speeds:
MEDIUM HIGH TURBO NIGHT
FILTER REPLACEMENT
♦ When the lter life expires (about 2000 hours of life time)
the light ring will blink red to remind you.
♦ Follow “installing the product” instructions
♦ After change the new lter, press and hold lter replace-
ment button (5) to reset.
♦ When the light ring ash in green three times, the lter
life span reset is complete.
LIGHT RING
♦ Press Light ring button (1), the light ring will keep one
color constantly, press this button again, the light ring will
start shifting color.
♦ While the light ring is on, press this button twice to turn
it off.
♦ While the light ring is off, press this button twice to turn
it on.
♦ Ambient light color cycle:
RED-BLUE-GREEN-YELLOW-PURPLE
Once you have nished using the appli-
ance:
♦ Select the minimum position (MIN) using the speed
control.
♦ Turn the appliance off, using the on/off button.
♦ Unplug the appliance from the mains.
♦ Clean the appliance.
Safety thermal protector:
♦ The appliance has a safety device, which protects the
appliance from overheating.
♦ When the appliance switches itself on and off repeatedly,
for reasons other than the thermostat control, check to
ensure that there are no obstacles that impede correct
air entry or expulsion.
♦ If the appliance turns itself off and does not switch itself
on again, disconnect it from the mains supply, and wait
for approximately 15 minutes before reconnecting. If the
machine does not start again seek authorised technical
assistance.
CLEANING
♦ Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
♦ Clean the electrical equipment and the mains connection
with a damp cloth and dry. DO NOT IMMERSE IN
WATER OR ANY OTHER LIQUID.
♦ Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
♦ Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
♦ Do not let water or any other liquid get into the air vents
to avoid damage to the inner parts of the appliance.
♦ Never submerge the appliance in water or any other
liquid or place it under running water.
♦ Do not wash the lter.
♦ Do not use a vacuum cleaner to clean the lter.
♦ Sterilize the lter under sunlight regulary.
♦ If the appliance is not in good condition of cleanliness, its
surface may degrade and inexorably affect the duration
of the appliance’s useful life and could become unsafe
to use.
To Next Page
Loading...
