9
ENGLISH
(Original instructions)
• Place the flange on the spindle. Place the
backing pad on the spindle and inner
flange, ensuring it is correctly located.
• Mount the fibre backed abrasive disc on
the backing pad.
• Fit the threaded outer flange and tighten
as explained in ‘Fitting the discs’.
Handy hints (Fig. E)
Hold your angle grinder firmly with one
hand around the side handle and the other
around the body of your angle grinder.
• Always position the guard so that as
much of the exposed disc as possible is
pointing away from you.
• Be prepared for a stream of sparks when
the disc touches the metal.
When grinding, always maintain the correct
angle between the disc and the work
surface (15°)(Fig. D). This increases the
removal capacity of the disc and avoids
unnecessary overloading.
Overload
Overloading will cause damage to the
motor of your angle grinder. This can
happen if your angle grinder is subjected to
heavy duty use for prolonged periods of
use. Do not in any circumstances, attempt
to exert too much pressure on your angle
grinder to speed up your work. The abrasive
discs operate more eciently when a light
pressure is exerted, thus avoiding a drop in
the speed of your angle grinder.
MAINTENANCE
Keep guards, air vents and the motor
housing as clear as possible of dust and dirt.
Wipe with a clean cloth and blow through
with a low-pressure air supply. Excessive
build-up of metal dust can cause tracking of
electrical current from the internal parts to
exposed metal parts.
Do not overload your angle grinder.
Overloading causes a reduction in speed
and eciency, causing your angle grinder to
become too hot. If this happens, operate
your angle grinder under no load for one or
two minutes until it has cooled to normal
operating temperature. Switching your angle
grinder o under load will reduce the life of
the switch.
Important! To assure product SAFETY and
RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this
manual) should be performed by authorized
service centers or other qualified service
personnel, always using identical
replacement parts.
Protecting the environment
Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your
BLACK+DECKER product needs
replacement, or if it is of no further use to
you, do not dispose of it with household
waste. Make this product available for
separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Reuse of
recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate
collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
BLACK+DECKER provides a facility for the
collection and recycling of BLACK+DECKER
products once they have reached the end of
their working life. To take advantage of this
service please return your product to any
authorised repair agent who will collect
them on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your
local BLACK+DECKER oce at the address
indicated in this manual. Alternatively, a list
of authorised BLACK+DECKER repair agents
and full details of our after-sales service and
contacts are available on the Internet at:
www.2helpU.com.
To Next Page
Loading...
