Black+Decker GL933 - Page 7

7
ENGLISH
(Original instructions)
outdoor use and marked accordingly. Up
to 30 m of 1.5 mm
2
HO5VV-F extension
cable can be used without loss of product
performance. Before use, inspect the
extension cable for signs of damage,
wear and ageing. Replace the extension
cable if damaged or defective. When
using a cable reel, always unwind the
cable completely.
Additional safety instructions for
grass trimmers
Warning! Cutting elements continue to
rotate after the motor is switched off.
uBe familiar with the controls and the
proper use of the appliance.
uBefore use, check the power supply
cord and extension cord for signs
of damage, ageing and wear. If a
cord becomes damaged during
use, disconnect the cord from the
mains supply immediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
uDo not use the appliance if the cords
are damaged or worn.
uWear stout shoes or boots to protect
your feet.
uWear long trousers to protect your
legs.
uBefore using the appliance, check that
your cutting path is free from sticks,
stones, wire and any other obstacles.
uOnly use the appliance in the upright
position, with the cutting line near the
ground. Never switch the appliance on
in any other position.
uMove slowly when using the appliance.
Be aware that freshly cut grass is
damp and slippery.
uDo not work on steep slopes. Work
across the face of slopes, not up and
down.
uNever cross gravel paths or roads
while the appliance is running.
uNever touch the cutting line while the
appliance is running.
uDo not put the appliance down until the
cutting line has come to a complete
standstill.
uUse only the appropriate type of
cutting line. Never use metal cutting
line or shing line.
uBe careful not to touch the line
trimming blade.
uTake care to keep the mains cable
away from the cutting line. Always be
aware of the position of the cable.
uKeep hands and feet away from the
cutting line at all times, especially
when switching on the motor.
uBefore using the appliance and after
any impact, check for signs of wear or
damage and repair as necessary.
uNever operate the appliance with
damaged guards or without guards in
place.
uTake care against injury from any
device tted for trimming the lament
line length. After extending new cutter
line always return the machine to
its normal operating position before
switching on.
uAlways ensure that the ventilation slots
are kept clear of debris.
uDo not use the lawn trimmer (edge
trimmer), if the cords are damaged or
worn.
uKeep extension cords away from
cutting elements.