Black+Decker MT300 User Manual

9
ENGLISH
(Original instructions)
Assembly
Fitting and removing the accessories
(fig. A - F)
Warning! Before fitting an accessory,
disconnect the tool from the mains supply.
Fitting a BLACK+DECKER / Piranha
accessory (fig. A - C)
• Hold the tool and squeeze the accessory
clamping lever (3).
• Slide the accessory (8) between the
shaft and the accessory holder making
sure the accessory engages all eight pins
on the holder and is flush with the shaft.
• Release the accessory clamping lever.
Note: Some accessories, such as scrapers
and blades can be mounted at an angle if
required (fig. C).
Removing a BLACK+DECKER / Piranha
accessory accessory (fig. A)
• Hold the tool and squeeze the accessory
clamping lever (3).
• Pull the accessory from the tool making
sure the accessory dis-engages from all
eight pins on the holder.
• Release the accessory clamping lever.
Warning: Gloves must be worn when
removing accessories as then may become
hot during use.
Fitting a sanding sheet (fig. D)
• Line up the sanding sheet (9) with the
sanding base (4) as shown.
• Press the sheet firmly and evenly onto the
sanding base, making sure that the holes
in the sheet coincide with the holes in the
base.
Removing a sanding sheet
• Pull the sanding sheet off the sanding
base (4).
Warning! Never use the sanding base
without a sanding sheet or accessory in
place.
Fitting the dust extraction adaptor (fig. E)
• Line up the dust extraction adaptor (5)
with the sanding base (4) as shown.
• Press the adaptor firmly and evenly in to
the sanding base.
• Secure the adaptor by turning the locking
nut (12) clockwise.
• Connect a vacuum cleaner to the dust
extraction adaptor.
Removing the dust extraction adaptor
• Turn the locking nut (12) anti-clockwise.
• Pull the dust extraction adaptor (5) out of
the sanding base (4).
Fitting alternative accessories (fig. F)
• Place the spacer (6) onto the collar (10).
• Place the alternative accessory (11) onto
the collar (10).
Carbide grout removal
blade.
(Part number -
X26125-XJ)
Carbide coated surface
ideal for clearing grout
and tile adhesive from
flat surfaces and for fast
stock removal of wood,
chipboard and
fibreglass.
Carbide rasp.
(Part number -
X26130-XJ)
Carbide coated surface
ideal for grout removal
and for fast stock
removal of plastics,
chipboard and
fibreglass.
Sanding Sheets.
Various grades for
sanding of wood,
painted and varnished
surfaces.

Black+Decker MT300 Specifications

General

Brand	Black+Decker
Model	MT300
Category	Power Tool
Language	English