5
ENGLISH
(Original instructions)
Symbols on the charger
Read all of this manual carefully
before using the appliance.
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
the voltage on the rating plate.
$
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
9062787X
Only use with charger 9062787X / N49424X
Features
This tool includes some or all of the following features.
1. On/off switch
2. Dust bowl
3. Charger
Fig. A
6. Dry pick up cloth lter
Charging the battery (Fig. B, C)
u Place the charger (3) into the charging port at the rear of
the unit (3a) and plug into the electrical outlet.
u Switch the electrical outlet on.
Use
u Before rst use, the battery must be charged for at least
10 hours.
Switching on and off (g. D)
u To switch the appliance on, press and hold the on/off
switch (1).
u To switch the appliance off, release on/off switch (1).
Warning! Never pick up wet applications with these units.
Optimising the suction force
In order to keep the suction force optimised, the lters must be
cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and lters (g.E & F).
Warning! The lters are re-usable and should be cleaned
regularly.
u Rotate the dust bowl (2) anti clockwise and remove from
the handle of the unit.
u While holding the dust bowl over a bin or sink, pull out the
lter (4) to empty the contents of the bowl.
u To replace the dust bowl, place it back onto the handle
and rotate clockwise until it locks rmly into position.
Warning! Never use the appliance without the lters.
Optimum dust collection will only be achieved with clean
lters.
Cleaning the dust bowls and lters
u The dust bowls and lters can be washed in warm soapy
water.
u Make sure that the lters and the dust bowl are dry before
re-tting.
Replacing the lters
The lters should be replaced every 6 to 9 months and
whenever worn or damaged.
Replacement lters are available from your BLACK+DECKER
dealer:
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
u Switch off and unplug the appliance/tool.
u Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
u Or run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your appliance/tool/
charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Protecting the environment
Z
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
To Next Page
Loading...
