※ You can set the motion detection function on the BlackSys Viewer : Configuration Settings >> Notion Detection.
Or directly from the BlackSys App : BlackSys Settings >> Motion Detection.
※ White LED will blink while motion recording is active.
※ Motion detection may fail when the vehicle is in extreme lighting conditions.
※ Recording time during parking mode may vary depending on the vehicles’ battery voltage.
※ Motion recording may continue according to changes in the environment, the sensitivity must be set to in accordance with your parking environment.
(E.g. When parking in an alley or underground, frequent movements may interfere with motion recording if set on a high sensitivity.)
6. Driving Information Check
- Configuration setting → GPS function → Driving Information
After you have set the storage intervals for driving information on the configurations settings, the desired data points will then be saved
at every programed interval.
To Next Page
