EN
5
Charging Warnings
Battery Charging
WARNING: Failure to exercise caution while using
this product and comply with the following warn-
ings could result in product malfunction, electrical issues,
excessive heat, FIRE, and ultimately injury and property
damage.
• NEVER LEAVE CHARGING BATTERIES UNATTENDED
DURING USE.
• NEVER CHARGE BATTERIES OVERNIGHT.
• Never attempt to charge dead, damaged or wet battery
packs.
• Never attempt to charge a battery pack containing different
types of batteries.
• Never allow children under 14 years of age to charge
battery packs.
• Never charge batteries in extremely hot or cold places or
place in direct sunlight.
• Never charge a battery if the cable has been pinched or
shorted.
• Never connect the charger if the power cable has been
pinched or shorted.
• Never attempt to dismantle the charger or use a damaged
charger.
• Never drop charger or batteries.
• Always use only rechargeable Li-Ion batteries designed for
use with this type of charger.
• Always inspect the battery before charging.
• Always keep the battery away from any material that could
be affected by heat.
• Always monitor the charging area and have a re extin-
guisher available at all times.
• Always end the charging process if the battery becomes
hot to the touch or starts to change form (swell) during the
charge process.
• Always connect the charge cable to the charger rst, then
connect the battery to avoid short circuit between the
charge leads. Reverse the sequence when disconnecting.
• Always connect the positive red leads (+) and negative
black leads (–) correctly.
• Always disconnect the battery after charging, and let the
charger cool between charges.
• Always charge in a well-ventilated area.
• Always terminate all processes and contact Horizon Hobby
if the product malfunctions.
CAUTION: All instructions and warnings must be
followed exactly. Mishandling of Li-Ion batteries can
result in a re, personal injury and/or property damage.
1. Connect the included USB cable rst to either the in-
cluded USB adapter, or an appropriate USB power source
(2A max).
2. Connect the USB cable to the charge port of the transmit-
ter. After approximately 45 seconds, the transmitter will
brie y show a charge icon on the screen and the battery
LED will ash blue.
Charging a fully discharged battery will take approxi-
mately 5.5 hours.
3. While charging, you can check the current capacity of
the battery by touching any button on the touchscreen.
The battery icon will appear on the screen, giving a visual
indication of the capacity.
4. When the charging process is complete, the battery LED
will stay solid and the icon will show full capacity.
5. Unplug the USB cable from the transmitter.
FPO
To Next Page
Loading...