QUICK START INSTRUCTION FOR BLADE IPTV RECEIVER
TURNING ON THE RECEIVER FROM STANDBY
Using the red “power” button at the top right of the remote
control to switch on from standby.
(The blue light at the front of
the receiver will change from a bright blue (standby) to a dim
blue which is on).
SELLECTING A CHANNEL
Press the “OK” button on the remote; this will bring up 14
names of the first page of the channel list. Use the “UP” or
DOWN” button of the remote control to move through the channel list. (You
can also move up or down a page at a time with the “PgUp or
PgDown buttons. When you have the channel you wish to view,
then press the OK button on the remote. You can also change
channels using the “channel + or – buttons, OR just enter the
channel number.
CHANGING FROM TV CHANNELS TO RADIO CHANNELS
To go to the Radio channels, select “MENU” then use the “<” or “>”
buttons and move to the Icon RADIO. Then press OK button,
and use up or down button to select.
To return to the TV channels, MENU – “<” or “>” until you see
the Icon TV, and select ALL.
EPG (Electronic Program Guide)
To Next Page
Need help?
General