INSTALLATION
Testing/replacing the UVC lamp
IMPORTANT:
Ensure the mains power supply is switched off and the power isolated
before removing the UVC cover.
1. Undo the four screws on the UVC electronics cover cap
2. Pull out the UVC electronics cover cap.
3. Unscrew the Quartz sleeve lock nut.
4. Remove the old bulb, and replace for new.
5. Complete steps 1-4 in the reverse order to reconstruct the unit – ensuring all O-rings
are correctly positioned.
IMPORTANT:
If there has been any damage to the unit, please return to the point of purchase for inspection.
This check should be performed whenever the UVC bulb or quartz sleeve is changed.
WARNING:
Dangerous Ultra Violet radiation. The rays from the UVC lamp are harmful to eyes
and skin. ALWAYS turn off the UVC electrical supply before any maintenance.
9
1
2
4
3
To Next Page
Loading...
