10 sec after the last operation, the timer display changes to the timer that
will run out next.
The assignment of that timer is displayed always by a flashing Cooking
Zone indicator. The amount of timers that are running can be identified by
the number of Cooking Zone indicator that are constantly on.
By toggling , you can display the timer values for each zone timer and
the minute minder. The assignment is always indicated by the flashing
Cooking Zone indicator. If no Cooking Zone indicator flashes, the
minute minder time is shown in the 2-digit Timer Display.
All zone timers can be erased by switching off the appliance into the S-
Mode using . A minute minder will not be erased, it will proceed operation
until run out.
To erase a timer in Operation Mode, you first have to select the timer by
toggling the Active/Deactive Timer Button until it is displayed. The value
can be erased then in 2 different ways:
•
Decrement by touching until '00' appears on the Timer Display.
•
Touch and simultaneously for 0,5sec until '00' is shown in Timer
Display.
After reaching the '00' of a zone timer, the assigned zone level will be set
to '0'.
The zone timer or minute minder run out is indicated acoustically by a buzzer
tone. This will be erased by touching any button for acknowledgement.
Key Lock
Key lock functionality is for locking the functions during the non-operation
of the cooktop. Modifications to setting e.g. increase heat settings will not
be possible. It is only possible to switch the appliance off.
The lock function is active, if the Key Lock button is pressed at least 2
sec. This operation is acknowledged by a tone. After successful operation of
more than 2 sec, the Key Lock lndicator flashes and the cooktop is locked.
The cooktop can only be locked in Operating Mode (B-Mode).
To Next Page
Loading...
