16
INSTRUCTIONS FOR THE USER
HOW TO CLEAN THE INNER OVEN DOOR
GLASS
One of the features of our cookers is that the
inner oven door glass can be easily removed for
cleaning without the aid of specialized personnel.
Just open the oven door and remove the support
securing the glass (g. 11).
ATTENTION!!
This operation can be done also with the door
tted on appliance, but in this way, pay attention
that when the glass is pull upwards, the force of
the hinges can close the door roughly.
LOCK AT LEAST ONE HINGE.
OVEN DOOR REMOVAL
The oven door can be removed to give easier access
to the oven when cleaning. To remove, proceed as
follows:
• Open the oven door and insert rivet (R) in the
hole (F) of the hinge (g. 12).
• Partially close the door, forcing it upwards at the
same time to free stop tooth and hinge sector.
• Once the hinge is free, pull the door forwards
tilting it slightly upwards to free sector.
• To reassemble proceed in the reverse order,
paying attention to the correct position of
sectors.
REPLACING THE OVEN LAMP (g.13)
WARNING: Ensure the appliance is switched
off before replacing the lamp to avoid the
possibility of electric shock.
In the event the oven lamp needs replacing,
the new lamp must comply with the following
requisites:
15 W - 230 V~ - 50 Hz - E 14 - and must be
resistant to high temperature (300°C).
To change the oven lamp follow the instructions :
• Draw out the side guide rails as described
above.Then remove the glass protection cap (V)
from the bulb socket, lifting it with a screwdriver
placed between the cap and the oven wall and
replace the lamp (L). Fit the accessories back in
reverse order.
OVEN SEAL
The oven seal guarantees the correct functioning
of the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is
damaged, contact our Service Centre and avoid
using the oven until it has been repaired.
12
13
11
Maintenance Schedule
The appliance should be checked by an au-
thorised person every year to ensure the safe
operation of the appliance. As part of the ins-
pection, the authorised person should also
check that the wall brackets are engaged and
securely mounted to the wall. This mainte-
nance is not covered by warranty.
To Next Page
Loading...
Need help?
General
