Blanco BIC64F - TROUBLESHOOTING AND ERROR CODES; Appliance or Cooking Zone Doesnt Start; Control Panel Displays U; Appliance or Cooking Zone Cuts Out

TROUBLESHOOTING AND ERROR CODES
The appliance or a cooking zone doesn’t start:
 The electrical connection to the power is faulty – Call an electrician.
 A fuse has blown – Check fuse box.
 The Key Lock function is active – reset as per the manual.
 The control panel buttons are coated in grease or water – clean as per the manual.
 An object is covering a control button – in general only one button can be pressed at a time, so
remove object to free-up buttons.
The control panel displays a “U” in one of the Cooking Zone Power LED displays:
 There is no cookware on the cooking zone – replace cookware on cooking zone.
 Cookware cannot be used with induction cooktops - replace cookware.
 The size of the base of the cookware is too small - replace cookware.
The appliance or a cooking zone cuts out:
 A fuse has blown – Check fuse box.
 A cooking zone has run unattended for a long period of time so has turned off – reset.
 A control panel button has been pressed or covered – remove object and reset.
 Cookware is empty and base has overheated – turn off appliance, let cool then restart with
cookware refilled.
The control panel LED displays show “
” or “Er03”:
 An object or liquid is covering some or all of the buttons – remove object or carefully clean the liquid
away from the control panel.
The control panel LED displays show “E2” or “EH”:
 The appliance has overheated – remove cookware from top and allow to cool.
The control panel LED displays show “E3”:
 The cookware has been detected, but is not suitable – remove cookware and replace.
The control panel LED displays show “E6”:
 The appliance has detected that the electrical input is not suitable – check power supply.
The control panel LED displays show “E8”:
 The appliance has detected that the ventilation at the bottom of the appliance has become blocked
– check vents are clear & clean, and that fans can be heard starting up periodically.
The control panel LED displays show “EC” or “E4”:
 There is a problem with the internal software – reset software (see next page).
If the problem persists, please contact Blanco using the contact details at the end of the manual.
13