9
4\TURNTABLE INSTALLATION
Hub (underside)
Glass
tray
Turntable
shaft
a. Never place the glass tray upside down. The
glass
tray should never be
restricted.
b. Both glass tray and turntable ring assembly
must
always be used during
cooking.
c. All food and containers of food are always
placed
on the glass tray for
cooking.
d. If glass tray or
turntable
ring assembly cracks
or
breaks, contact your nearest authorized
service
center.
Turntable ring
assembly
5\INSTALLATION
AND
CONNECTION
1.This
appliance
is only intended for domestic
use.
2.This oven is intended for built-in use only.It is not intended for
counter-top
use or
for
use inside a
cupboard.
3. Please observe the special
installation instructions.
4.The
appliance
can be installed in a 60cm wide
wall-mounted cupboard(at
lease
55cm
deep and 85cm off the
floor).
5.The
appliance
is fitted with a plug and must only be
connected
to a properly
installed
earthed
socket.
6.The mains voltage must
correspond
to the voltage specified on the rating
plate.
7.The socket must be installed and
connecting
cable must only be replaced by
a
qualified
electrician.If
the plug is no longer to
accessible
following
installation,an
all-pole
disconnecting
device must be present on the
installation
side with a
contact
gap of at lease
3mm.
8.Adapters,multi-way
strips and
extension
leads must not be used.
Overloading can
result in a risk of
fire.
The accessible surface
may be hot during
operation.