These 5 extra programs in addition to the previous ones can be selected
directly using the program selector button.
This button must be pressed (the light comes on) after selection of the
“main” program (1,2,3,4 or 5).
This function is retained in the memory, so the button has to be pressed
again (the light goes out) if the user wishes to execute one of the 5 main
programs at the next cycle.
In this dishwasher model all the programming operations are possible
only with closed door.
With open door, on the 3-FIGURE DISPLAY (12), “section 3.1” will
appear the symbols
---
.
Keep pressing the PROGRAM SELECTION button (2) until the indicator
light corresponding (3) to the desired program illuminates.
To annul the current program, press the START/PAUSE button (4) for a
few seconds, until the PROGRAM STARTED indicator light (5) stops
flashing. Now press the START/PAUSE button (4) again until “P0”
appears on the display (about 10 seconds).
To modify the program keep the START/PAUSE button (4) pressed for a
few seconds, until the PROGRAM STARTED indicator light (5) stops
flashing, then select the new program following the instructions provided
above; press the START/PAUSE button (4) again and keep it pressed
for a few seconds, until the indicator light (5) starts to flash again.
To Next Page
Loading...
