Blanco BWC6X User Manual

• Clean the fan and other surfaces of the rangehood regularly using a cloth moistened with metholated spirits or
non abrasive liquid detergent.
• The active carbon help to lters purify the air that is replaced in the environment.
The lters are available upon request from your retailer.
The lters are not washable or reusable and must be replaced at a maximum every four months. The saturation of
the active carbon lter depends on the frequency of use of the appliance , by the type of cooking and the regularity
of the cleaning of the aluminum lters.
• The lights are designed to be used during cooking – not for prolonged general illumination of the environment.
Prolonged use of the lights will reduce the duration of the bulb.
• Light Replacement - Incandescent.
• Remove the aluminium lters from the rangehood.
• Un-screw the globe.
• Replace the globe.
• Re-install the aluminium lters.
Globe: Tubular E14 40Watts 240volts
• Light Replacement - Halogen
12 volt 20 W Halogen.
Remove the glass retaining ring and glass.
Replace the globe with another of the same type.
Replace the glass and retaining ring.
• Controls: (Fig.9 B) Symbols are explained below for all models except BWCG90X:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
G = MOTOR WORKING indicator.
• Controls: (Fig.10) only for BWCG90X
Push-button A = on/o lights switch
Push-button B = on/o rangehood switch. The appliance switches on at speed level 1, If the rangehood is on
depress the push-button for 2 sec. to switch o the rangehood . If the cooker hood is at speed level 1 it will not be
necessary to depress the push-button to switch the rangehood o. Decreases the motor speed.
Display C = indicates the motor speed level selected and activates the timer.
Push-button D = switches on the rangehood . Increases the motor speed. Touching the key at 3rd speed, the
intensive function runs for 10’, then the appliance go back to work at the original speed. During this function the
display blinks.
Key E = The Timer times the functions on activation for 15 minutes, after which they are switched o. The Timer
is deactivated by re-pressing Key E. When the Timer is activated the decimal point must ash on the display. The
Timer cannot be activated if the intensive speed is functioning.
•The “clean air” function is activated by pressing key E for 2 seconds when the appliance is switched o. This switches
the motor on for 10 minutes every hour at the rst speed. During functioning a rotary movement of the peripheral
segments must be visualised on the display. When this time has passed the motor switches o and the xed letter
“C” must be visualised on the display until the motor re-starts after 50 minutes for another 10 minutes and so
on. Press any key apart from the light keys to return to normal functioning. Press key E to deactivate the function.
• Active carbon/grease lter saturation:
- When display item C ashes, at a speed where it alternates with the letter F (e.g. 1 and F), the grease lters must
be washed.
- When display item C ashes, at a speed where it alternates with the letter A (e.g. 1 and A), the carbon lters
must be replaced.
After the clean lter has been positioned correctly, the electronic memory must be reset by pressing button A for
approximately 5 seconds, until the indication F or A shown on the display C stops ashing.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY BREACHING
THE ABOVE WARNINGS.
- 8 -

Blanco BWC6X Specifications

General

Brand	Blanco
Model	BWC6X
Category	Ventilation Hood
Language	English