Instructions for Use
(gas cooktop)
IGNITION AND OPERATION OF THE BURNERS
RECOMMENDATIONS
In case of electric power failure, it is necessary to carry out the above-described ope-
rations by putting a gas lighter or a flame near the burner (in such an event, pay the
utmost attention not to burn yourself).
The safety valve (for models where such item is provided) intervenes in case of acci-
dental flame failure, blocking the gas delivery (e.g.: air draughts, spillage of liquids,
etc.).
In any case, the ignition device must not be actuated for longer than 15 seconds.
Should the ignition manoeuvre fail, or should the burner be accidentally turned off,
immediately close the actuation knob and repeat the ignition after one minute at
least.
Once the ignition has taken place, adjust the flame according to your needs.
The control panel houses the knobs for operation of the gas burner.
In order to ignite a burner, it is necessary to depress the knob while rotating it anti-
clockwise, till the index is aligned with the position corresponding to the maximum
gas delivery (i.e. the large flame symbol). As far as the
models equipped with a safety valve are concerned, once
the flame is lit hold the knob depressed for about 3-4
seconds till the device keeps the burner automatically lit.
If the burner fails to ignite wait one minute for the gas to
dissipate before attempting to reignite. At this moment it is
possible to adjust the flame intensity by rotating the knob
anticlockwise
from such maximum position to the
minimum
one (i.e. the small flame symbol).
In order to turn the burner off, rotate the knob clockwise bringing the index back to
the position corresponding to the closure symbol ( ).
To Next Page
Loading...
Need help?
General
