MACHINE MANUAL BRB-2800
SAFETY
© 2010 Blastpro Manufacturing Inc.
®
6
SECTION 2.1: GENERAL
Read and understand this Machine Manual prior to operating or performing
maintenance on the BRB-2800.
This Machine Manual has been developed as a guideline for machine operation.
It is not a substitute for proper organizational training and management.
All machine operators and maintenance personnel should be properly trained in
operation and safety features of the BRB-2800.
Make these operating instructions accessible to all operating and maintenance
personnel.
Never weld, modify, cut or grind components of the BRB-2800 without prior
written consent from the manufacturer.
Never use aggressive cleaning chemicals to clean the machine.
All operators and maintenance personnel should receive training on the dangers
of carbon monoxide, or CO. All personnel should be able to identify signs and
symptoms of CO poisoning. Common signs associated with overexposure
include headache, nausea, weakness, dizziness, lethargy, visual disturbances,
and changes in personality and/or loss of consciousness.
SECTION 2.2: MAINTENANCE AND WEAR PART REPLACEMENT MODES
Maintenance mode is defined as placing the machine in a configuration, which
minimizes potential electric, hydraulic or stored energy hazards.
In general, the machine should be placed in Maintenance Mode prior to
performing any maintenance and/or troubleshooting activities.
MAINTENANCE MODE:
1. Move the machine to a level surface.
2. Reduce machine RPM to low idle.
3. Turn key switch to “OFF” position.
4. Remove key from switch to prevent accidental or unintended starting.
5. Block wheels to prevent the machine from moving.
6. Turn the LP bottle valve to “CLOSED” position.
7. Allow engine and exhaust tube to cool down prior to carrying out any
maintenance work.
To Next Page
Loading...