BlastPro BRB-2800 - Page 23

MACHINE MANUAL BRB-2800
OPERATION
© 2010 Blastpro Manufacturing Inc.
®
13
1
2
3
4
5
6
7
8
9
FIGURE 3.1.1
SECTION 3.2: SHUT DOWN
At end of shift or work day:
1. Move machine to level ground for storage.
2. Use the rocker switch in the left control lever to lower the cylinders until
the front caster lifts off of the ground.
3. Pull throttle up to low idle.
4. Turn key switch to “OFF” position.
5. Remove key to protect against unauthorized operation.
6. Turn the LP bottle valve to “CLOSED” position.
For long term storage:
1. Move machine to level ground in a secure location for storage.
2. Lift blade to upper-most position.
3. Pull throttle up to low idle.
4. Turn key switch to off position.
5. Remove the blade and/or the blade holder from the front of the machine.
6. Turn key switch to start position until the motor starts.
7. Use the rocker switch on the left control lever to lower the cylinders until
the front caster lifts off of the ground.
8. Turn key switch to off position.
9. Remove the key to protect against unauthorized operation.
10. Turn the LP bottle valve to “CLOSED” position.
11. Remove LP bottle and store in a secure location.
12. Cover the BRB-2800 to protect it from dust and moisture.