MACHINE MANUAL BRB-2800
MAINTENANCE
© 2010 Blastpro Manufacturing Inc.
®
17
SECTION 4.1: MAINTENANCE INTERVALS
Daily, or at the beginning of each shift
Never inspect a pressurized hydraulic system with your hand. Pinhole leaks can
inject hydraulic fluid into the body, which can result in serious injury. If additional
assistance is required consult your Blastpro representative, authorized Blastpro
distributor, or qualified hydraulic systems professional.
Always wear leather gloves and use caution when handling blades.
1. Check engine oil.
2. Check hydraulic oil level.
3. Inspect hydraulic oil cooler for obstructions (dirt, paper, etc.).
4. Inspect hydraulic components and hoses for leaks or abrasions.
5. Inspect engine air filter*.
6. Inspect belts for proper tension.
7. Inspect blades for excessive wear.
8. Check air intake and cooling areas*.
9. Inspect drive wheels for wear.
Every 25 Hours
1. Service engine pre-cleaner element*.
2. Grease all blade and cylinder pivot pins.
Every 50 Hours
1. Change hydraulic oil filter.
2. Top off hydraulic oil tank.
3. Tighten rear wheel nuts
4. Grease front caster and inspect for wear or damage.
5. Blow out hydraulic oil cooler fins.
Every 100 Hours
1. Replace engine air cleaner element*.
2. Change engine oil*.
3. Replace engine oil filter*.
*Perform these maintenance activities more frequently under extremely dusty,
dirty conditions.
To Next Page
Loading...