Name: Blastrac BGS-250
Brand: Blastrac
Rating: 4 (1 reviews)

Other manuals for Blastrac BGS-250

Operating Manual83 pages

Questions and Answers:

M
Michael CampbellAug 2, 2025
What to do if Blastrac Floor Machine will not start, green control light is turned OFF?
- W
  wilkinsonjacquelineAug 2, 2025
  If your Blastrac Floor Machine won't start and the green control light is off, several issues could be the cause. First, ensure that your connected dust collector has sufficient suction power and is turned on. Next, inspect the dust hose and its connections for any blockages or damage. Also, check the measuring point inside the dust hose connection for blockages. Verify that the air hoses and connections are free from blockages or twists. Examine the filter and replace it if it's clogged. Lastly, confirm that the differential pressure switch is correctly set to -10mbar.
Z
zmooreAug 7, 2025
Why is my Blastrac Floor Machine making excessive vibration and/or unusual noises?
- J
  Jessica BeanAug 7, 2025
  Excessive vibration and unusual noises in your Blastrac Floor Machine can stem from a few key issues. Start by checking for worn or broken grinding tools and replace them. Next, inspect the bearing on the axle drive shaft and replace it if defective. Finally, examine the coupling for any debris deposits and clean it thoroughly.
C
Christie StevensAug 13, 2025
What to do if Blastrac Floor Machine motor triggers while running?
- S
  Sandra DoyleAug 13, 2025
  If your Blastrac Floor Machine motor triggers while running, it could be due to a motor protection switch triggered by an overload. Try reducing the additional load. If that doesn't solve the problem, the motor itself might have a defect, so you should check the motor.