EasyManuals Logo

Blaupunkt 400 Series User Manual

Blaupunkt 400 Series
Go to English
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
EN
15. Clock
The unit has an internal clock so you can view the time on
the display by pressing the DIS button until the desired
information appears.
The time can also be displayed when the unit is turned off,
see "SETTINGS".
To display the time when the unit is off the vehicle's ignition
must be on; if the ignition is off, the display turns off
completely to reduce power consumption.
To set the clock see "SETTINGS".
16. Steering wheel remote control (SWC)
You can assign the steering wheel remote control buttons (if
available) to the existing functions in the unit's SWC
configuration.
Storing functions
Open VARIOUS -> SWC in the device settings.
Then, with the right button/knob select the function you
wish to programme and confirm with the right button/knob.
The unit will now wait for a signal from the steering wheel
remote control and display PRESS KEY AT STEERING WHEEL
CONTROL FOR 1SEC. Press the desired button on the
steering wheel remote control.
If the button has been successfully programmed, the display
will show OK. Repeat the procedure if the unit displays FAIL
or does not respond at all.
Repeat this step for all buttons to be programmed.
Note: If storing is not possible even after several attempts
or is not performed correctly, check the device connections
or the compatibility of the interface used. If FAIL is always
displayed, the error is probably in the remote control or in
the interface. If the unit does not respond at all, make sure
that the remote control/interface is (properly) connected.
Note: The programmable SWC interface of this device
includes analogue steering wheel presets. The device works
with analogue remote controls that control functions
through different resistance values (resistance matrix) at the
connector (up to two control lines and 1x GND).
Some remote controls are directly compatible, others
require a SWC interface. The steering wheel remote controls
cannot be connected without an interface via CAN.
For more information on the accessories suitable for your
vehicle, contact your specialist dealer or the vehicle
manufacturer.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Blaupunkt 400 Series and is the answer not in the manual?

Blaupunkt 400 Series Specifications

General IconGeneral
Display TypeLCD
BluetoothYes
Media PlaybackMP3, WMA
Remote ControlYes
Tuner BandsFM/AM
AUX InputYes

Related product manuals