EN
Connections and designations
① SWC: Connection to the steering wheel remote control –
external adapter/interface may be required, see "STEERING
WHEEL REMOTE CONTROL (SWC)"
② SUB/SW: Subwoofer output for connecting an active
subwoofer
③ PREAMP- OUT (RF, LF, RR, LR): Preamp outputs for
connecting an external amplifier
④ AUX-IN: Connection for external audio source
⑤ EXT-MIC: Connection for external microphone; switched
automatically when microphone is connected
⑥ DAB antenna: SMB connector with 12 V phantom power
supply (max. 150 mA)
⑦ FM/AM Antenna: DIN port
⑧ Terminal block section A (power supply), section B
(speaker) and device fuse (10 A flat car fuse, red)
RADIO MUTE: Radio muting via ground contact
PERM. 12 V+/ BATT (Cl.30): Battery
AUTO ANTENNA: Switchable power supply for active
antennas or control voltage for external power
amplifiers/subwoofers (12 V, max. 150 mA)
ILLUMINATION: Vehicle lighting input, required for
automatic button/display brightness switching. The input
requires 0 V/12 V. PWM signals may cause the display to
flicker and must not be used.
ACC/IGNITION (cl.15): Ignition positive switch
GND (cl.31): Ground
Note: This unit does not support CD changers or other
components that are compatible with older Blaupunkt units.
Note: Be sure to connect the ignition and fixed positive
pole correctly, otherwise the unit will have an increased
current draw and not shut down completely, which can
discharge the car battery!
19. Useful information | Technical data
Warranty
For current warranty terms, please visit
www.blaupunkt.com. If no additional information is
provided here, local regulations apply.
Servicing
Contact the Blaupunkt dealer from whom you purchased
the product if you need repair service. For more information
on service partners in your country, please visit
www.blaupunkt.com
Information on service partners in
your country.
Technical data
Mounting angle of a unit with CD -10 to +18°
Power Supply – remote control
(optional, battery not included) 3 V, CR2025
Operating voltage: 10.5; - 14.4 V
Current consumption during operation < 10 A
Off (cl. 15/ACC off): < 5 mA
USB connector 5 V max. 1 A