21
ACM 3250 GB
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Tape operation
Automatic seek tuning start
Prerequisite:
The priority for traffic announcements has
been activated.
When leaving the reception area of the tuned
in traffic programme station while listening to
a tape or after having turned down the vol-
ume completely, the system will automati-
cally start searching for a new TA program-
me.
If no such station is found within approxi-
mately 30 seconds, tape operation will be
stopped and a warning beep will sound. To
switch the warning beep off, proceed as
described above.
Adjusting the volume for traffic
announcements and the warning
beep
This volume was preset at the factory.
Inserting a tape
• Turn on the set.
• Insert a tape.
Insert the tape with side A or 1 showing up, the
open side facing to the right.
The display shows “TAPE” while the tape is
being played.
Removing a tape
• Press .
The cassette will eject.
Fast Forward
Starting and stopping Fast Forward
• press the
button half-way.
Appendix
Mechanism/cassette tapes
To avoid possible problems, you should not
use cassette tapes longer than 60 or 90
minutes (C60/C90). Store your tapes in a
cool place away from dirt, dust and tempera-
tures exceeding 50 ° Celsius. Allow very cold
tapes to warm up before playing them in
order to avoid uneven tape transport. After
approximately 100 hours of use, dust par-
ticles collected on the playback head or roller
may lead to tape run problems and sound
distortions.
Use a head cleaning tape to remove normal
dirt build-up. For tougher cases, use a cotton
swab (Q-Tip) soaked with alcohol. Do not
attempt to clean by inserting a hard object
into the player!
To Next Page
Loading...
Need help?
General
